User's Manual

APPENDIX D
SOFTWARECOMMANDS
Definitions
Listed below in alphabetical order are the definitions of the ESTeem software commands.
Revised: 27 Mar 01
APX D-7
RFcycles
This command defines the number of cycles the ESTeem
will transmit when programmed with the RADIO
COMMAND.
Factory default = 10.
RFPower (0-255)
This command sets the output RF power of the ESTeem.
These values are calculated and tested at the factory and
should not be adjusted without consulting calling Customer
Support at 509-735-9092.
Caution: Improper adjustment of this value can cause
damage to the ESTeem transmitter.
ROUTe (l#,r1,r2,r3,)
The ROUTE sets up the route table in the ESTeem.
l # = User defined route number. Route numbers 1
to 16 may be used.
r1 = Address of first repeater. Address numbers
from 1 to 254 may be used.
r2 = Address of second repeater. Address numbers
from 1 to 254 may be used.
r3 = Address of third repeater. Address numbers
from 1 to 254 may be used.
Note: See APPENDRU Command.
Factory default = 0.
RXData (1-255)
This command defines the time (milliseconds) the receiver
waits after a carrier detect before starting the receive
sequence. This value is optimized at the factory and should
not be changed.
Factory default = 1.
RXEnd (1-255)
This command defines the time (milliseconds) to wait after
the last character is received before reinitializing the
receiver.
Factory default = 1.
RXSIGNAL (on/off)
This command enables the signal to noise ratio meter
output. Output level varies from 0 to 248 (248 being the
highest reading).
ON: Enabled.
OFF: Disabled.
Factory default = OFF.
SAve
The save command. The execution of this command stores
the current command values and switches.
Note: Please wait approximately two seconds after
executing the SAVE command before turning off
power to the ESTeem.
SECURITY (off or 1- 100000)
The security command disables programming the ESTeem.
1 to 100000 This feature is enabled when you enter a
number from 1 to 100000. When enabled the
ESTeem will return a Security ON message.
To disable security enter SECURity xxxxxx.
xxxxxx = your predefined security number.
When disabled the ESTeem will return a
Security Off message.
OFF Security disabled.
Factory default = OFF.
SENDPACK (0-255)
Send packet (SENDPACK) command. The value specifies
an ASCII character used to signal when to send the
packet. If set to a value of 255 the command is disabled.
The factory default value is 13 (Return).
SEL/A1 (1-255)
The SEL/A1 command sets the transceiver for a specific
frequency.
SEL/N1 (1-56635)
The SEL/A1 command sets the transceiver for a specific
frequency.