User's Manual

APPENDIX C
SPECIFCATIONS
ESTeem System Status Message Table
Revised: 27 Mar 01
APX C-2
Listed below are the ESTeem System Status Messages and their definitions. To receive these messages, TYPSYSTEM must
be ON (See APPENDIX D, DEFINITIONS). All System Status Messages have a bell (O7H or CTRL G) preceding the
message except when Messform is ON. If Messform = OFF Line A will be displayed. If Messform = ON Line B will be
displayed.
1. A "CONNECTED TO XX"
B SSO1-xx
This message is caused by either receiving a reply
from a Log On Packet, receiving a Log On Packet, or
by typing LINK when connected and in the
COMMAND MODE. XX is the address of the
modem connected to.
2. A "DISCONNECTED FROM XX"
B SSO2-xx
Tells that you have been disconnected from the
device you were originally connected to (xx is unit
address).
3. A "LINK DOWN"
B SSO3
This message occurs after sending the last retry data
packet and receiving no response from the
destination node. This message usually indicates a
hard failure -i.e. destination node not energized,
wrong baud rate, (not compatible between units)
improper transmit/receive frequency between nodes,
etc.
4. A "CURRENTLY NOT CONNECTED!"
B SSO4
The Disconnect was issued while the modem was not
connected to another modem or when LINK is typed
in the COMMAND MODE when you are not
connected.
This message is displayed when the modem is configured in
the monitor mode.
5. A "FAILED TO CONNECT!"
B SS05
This message occurs if the modem fails to connect.
6. A "FAILED TO DISCONNECT!"
B SS06
This message occurs if the modems are connected
and are unable to disconnect.
7. A "USING FACTORY DEFAULTS"
B SS07
This command states when factory defaults have
been enabled.
8. A "REMOTE PROGRAMMING"
B SS08
This message is displayed when the ESTeem has
been placed in the remote programming mode.
9. A "PHONE MODEM CONNECTED.
INFRARED PORT DISABLED"
B SS09
This message is displayed when the ESTeem phone
port has received an in-coming call.
10. A "PHONE MODEM DISCONNECTED.
INFRARED PORT ENABLED"
B SS10
This message is displayed when the ESTeem port
has been disconnected.