User's Manual

APPENDIX C
SPECIFCATIONS
ESTeem Command Error Message Table
Revised: 27 Mar 01
APX C-1
Listed below are the ESTeem Command Error Messages and their definitions. To receive these messages, TYPSYSTEM
must be ON (See Appendix D, Definitions). All System Status Message have a bell (O7H or CTRL G) preceding the
message except when Messform is ON. If MESSFORM = OFF Line A will be displayed. If MESSFORM = ON Line B
will be displayed.
1. A "TOO MANY CHARACTERS FOR
COMMAND"
B EMO1
This message will be displayed if more than the
allocated number of characters are typed for a com-
mand. This is because some commands are truncated at
a length of 8 characters.
2. A "AMBIGUOUS COMMAND"
B EMO2
This is the case of not enough characters being entered
to uniquely identify a command.
3. A "INVALID ARGUMENT"
B EM03
This is displayed when a non valid value is given to a
Command. Example; a value of O cannot be given to
FRACK because the only valid values are 1-255.