User's Manual

CHAPTER 6
ANTENNAS
Revised: 27 Mar 01
6-7
Model 192C and 192F Typical Indoor & Mobile
Antenna Installation Diagram
UHF Male
Connector
ANTENNA FEEDLINE
RECOMMENDATIONS
1. Up to 50 ft. use RG-8
Coax (EST P/N AA233).
2. Over 50 ft. call EST.
TNC Male
Connector
12 VDC POWER SUPPLY
RECOMMENDATIONS
EST P/N AA174
Battery Packs
2 Pin Molex
Connector
RS-232C
Setup
Switches
RS-232C, 422, & 485
Interface Connector
RS-232C,422, or 485
INTERFACE CABLE
EST P/N AA06,
AA061, AA07, or
custom depending on
device.
Omni-Directional Antenna
Magnetic Mount. EST P/N
AA19C/F with 19 inch
rubber duck radial with
approximately 12 ft. of
integral RG-58 cable for
direct connection to
ESTeem.
Omni-Directional Antenna
Permanent Mount. EST
P/N AA20C/F with 29 inch
vertical radials.
ANTENNA
RECOMMENDATIONS
Omni-Directional Antenna
Vehicle Mount. EST P/N
AA191C/F with integral 17
ft. of RG-58 cable for
direct connection to
ESTeem.
NOTES
1. Use coax cable runs as short as practical to
minimize cable losses.
2. Vapor wrap all external antenna coax
connections with vinyl wrap (EST Part No. AA241)
and apply Scotchkote Electrical Coating (EST Part
No. AA242).
3. Contact EST for recommendations regarding
antenna mounting hardware and installation tips.
4. Ground antenna structure, base and lightning
arrestor.