User's Manual

CHAPTER 6
ANTENNAS
Revised: 27 Mar 01
6-6
Model 192M Typical Indoor & Mobile
Equipment Diagram
Omni-Directional Antenna
Magnetic Mount. EST P/N
AA19M with 19 inch
rubber duck radial with
approximately 12 ft. of
integral RG-58 cable for
direct connection to
ESTeem.
UHF Male
Connector
ANTENNA FEEDLINE
RECOMMENDATIONS
1. Up to 50 ft. use RG-8
Coax (EST P/N AA233).
2. Over 50 ft. call EST.
TNC Male
Connector
12 VDC POWER SUPPLY
RECOMMENDATIONS
EST P/N AA174
Battery Packs
2 Pin Molex
Connector
User’s
Device
RS-232C
Setup
Switches
RS-232C, 422, & 485
Interface Connector
Omni-Directional Antenna
Permanent Mount. EST
P/N AA20M with 21 inch
vertical radials.
RS-232C,422, or 485
INTERFACE CABLE
EST P/N AA06,
AA061, AA07, or
custom depending on
device.
ANTENNA
RECOMMENDATIONS
NOTES
1. Use coax cable runs as short as practical to
minimize cable losses.
2. Vapor wrap all external antenna coax
connections with vinyl wrap (EST Part No. AA241)
and apply Scotchkote Electrical Coating (EST Part
No. AA242).
3. Contact EST for recommendations regarding
antenna mounting hardware and installation tips.
4. Ground antenna structure, base and lightning
arrestor.
Omni-Directional Antenna
Vehicle Mount. EST P/N
AA191 with integral 17 ft.
of RG-58 cable for direct
connection to ESTeem.