User's Manual

Edge 900
User’s Manual
Revised: 19 Jan 2017 6 of 9
Edge 900 MHz Antenna and Cable Configurations
ESTeem offers different types of antennas for both indoor and outdoor configurations. This device has been designed to
operate with the antennas listed below, and having a maximum gain of 7 dB. Antennas not included in this list or having a
gain greater than 7 dB are strictly prohibited for use with this device. The required antenna impedance is 50 ohms.
This radio transmitter ESTeem Edge 900 MHz (HVIN: 217ES) has been approved by Industry Canada to operate with the antenna
types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated.
Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly
prohibited for use with this device.
Le present emetteur radio ESTeem HVIN: 216AD a ete approuve par Industrie Canada pour fonctionner avec les types d'antenne
enumeres ci-dessous et ayant un gain admissible maximal et l'impedance requise pour chaque type d'antenne. Les types
d'antenne non inclus dans cette liste, ou dont le gain est superieur au gain maximal indique, sont strictement interdits pour
l'exploitation de l'emetteur.
Warning: Only the tested cable lengths and antennas provided by EST meet the FCC and DOC maximum peak output
power requirements. Any other combination of antennas or coax cables is not authorized. To reduce potential radio
interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated
power (e.i.r.p.) is not more than that permitted for successful communication.
Part Number: AA20DMs
 Omni-directional direct mount antenna, 2 dBi gain.
 Indoor and outdoor applications.
 There must be a minimum separation distance of 23
cm. from the antenna to the user. See Warnings.
Part Number: AA20Es900
 Omni-directional external pole mount antenna, 7 dBi
gain with 3-ft. integral feedline and connector.
 Outdoor applications.
 There must be a minimum separation distance of
23cm. from the antenna to the user. See Warnings.
Part Number: AA203Es900
 Directional pole mount antenna, 7 dBi gain with 3-ft.
integral feedline and connector.
 Point to point and point to multi-point outdoor
applications.
 There must be a minimum separation distance of 23
cm. from the antenna to the user. See Warnings.
Warnings:
Only pre-made coax cables from the factory used in
conjunction with either the AA20Es900 omni-directional and
AA203Es900 directional antennas meet all FCC Section
15.247(b) EIRP maximum power requirements.
Transmit/Receive
Antenna Port