User's Manual

Deleting a Device From a Scene
1. Press and hold the Scene button corresponding to the scene number you wish to delete the
device from. A device may be included in multiple scenes, and can only be deleted from one
scene at a time.
2. Press SELECT to place the remote in Scene delete mode.
3. Press the Learn button on the device to be deleted. Unlike Scene Include mode, the remote will
exit Scene Delete mode as soon as the device has been deleted.
Resetting to Factory
1. Press the include/delete button. The green LED lights solid and the channel LED(s) turn off.
2. Simultaneously press and hold BOTH SELECT buttons for 5 seconds or until ALL LEDs on the
remote light solid. Note that if a group LED turned on, or if the red LED at the top right of the
remote turned on, the buttons weren't pressed "simultaneously" enough and you are in either
include or delete mode. Wait for the mode to time out and try these steps again.
3. Release the select buttons within 5 seconds of the LEDs lighting solid.
Error Indication
Both the green LED and the red LED on the top of the remote will simultaneously blink 3 times.
NOTE
The Forest IMS Motor is a Z-Wave enabled device and is fully compatible with any Z-Wave enabled
network. Z-Wave enabled devices displaying the Z-Wave logo can also be used with Forest IMS
regardless of the manufacturer. Forest IMS can also be used in other manufacturer’s Z-Wave enabled
networks and all listening devices act as repeaters, regardless of vendor.
NOTE
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by Forest Group and Electronic Solutions, Inc. could
void the user's authority to operate the equipment.