User's Manual

12/1/03
Electronic Solutions, Inc.
11811 Upham St. Unit #2, Broomfield, CO 80020-2710
voice: 303-469-9322 fax: [phone] www.elec-solutions.com
Release the button, the red LED will come on, and the unit is ready to learn the 1
st
transmitter.
If you press and release the learn button and the LED does not come on, the list is “full” and no more transmitters
can be learned.
Note that in the learn mode (button is pressed or the LED is on), the receiver is not passing commands to the
RP24/RP60 system. Once the transmitter is learned, and if the STOP button is still held, the stop command will be
sent to the system.
INSTRUCTION TO THE USER
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
* Consult the dealer or an experienced radio/TV technician for help.
In order to maintain compliance with FCC regulations, shielded cables must be used with this equipment.
Operation with non-approved equipment or unshielded cables is likely to result in interference to radio and TV
reception. The user is cautioned that changes and modifications made to the equipment without the approval of
manufacturer could void the user's authority to operate this equipment.