User's Manual

12/1/03
Electronic Solutions, Inc.
11811 Upham St. Unit #2, Broomfield, CO 80020-2710
voice: 303-469-9322 fax: [phone] www.elec-solutions.com
RR24 Installation Guide
Connect the RR24 Radio Receiver to the RP24/RP60 as shown
The RR24 unit must connect to an Eye Jack on a RP24/RP60 or splitter. If the eye connects to a splitter, then the
Main jack next to it must connect to the Eye Jack on an RP24/RP60.
For best reception, the RR24 should be mounted with the antenna pointing up, and it should not be placed on or near
a metal surface.
The RR24 unit can learn up to 5 different transmitters to work with. It ships from the factory with NO transmitters
learned, you must train it in the field to work with your specific transmitters.
Press and release the “Learn Transmitter” button on the RR24,
the red LED will come on if 5 transmitters have not already been learned,
the unit is now ready to learn another radio transmitter:
Press stop on the radio transmitter, (buttons other than stop are ignored)
The LED on the RR24 will go out,
this transmitter is added to the list of known transmitters,
the RR24 is now operating normally again.
Note that if this transmitter is already known, this button will be ignored and the LED will remain lit.
If no stop command is received within 10 seconds,
the red LED will flash off, then on, and then go out. NO new transmitters were learned!
(Note that if no transmitters are known at all, then the LED will turn back on immediately)
If the red LED is on and the learn button is pressed and released,
the red LED will turn off with no changes to the learned list.
(Note that if no transmitters are known at all, then the LED will turn back on immediately)
If no transmitters are known, (as shipped from factory)
then the red LED will turn on as soon as the unit is plugged in.
Note that the LED will flash every 10 seconds until a transmitter is learned.
Pressing the learn button has no meaning while in this mode (the LED will turn off while the button is pushed).
Press and hold the learn button for 5 seconds to clear all known transmitters, (the LED will blink on and off.)