Manualshelf

User's Manual

ManualsBrandsElectronic Solutions ManualsElectronicsRemote Control
12345678910
RF Switch Interface, v1.0 Installation Guide
www.elec-solutions.com © 2012 Electronic Solutions, Inc. Page 2 of 10
Description
Side View
Top View
LED (light emitting diode)
A single red/green LED provides visual feedback for startup blinks,
network invite, and network reset actions.
Network button
Pushbutton switch used to join the RF Switch Interface to an existing ESI
RF network, or used to reset network information on the RF Switch
Interface.
Dry contact terminals - Groups
Open and Close contacts to control up to four groups of ESI RF devices.
Dry contact terminals - Power
DC - and DC + contacts connected to the battery.
DIP Switches
Used to configure different modes of operation.
Spring Loaded Terminals
WIRE: Use 20-26 AWG solid conductor wire.
Insert wire: ―Push-in‖ wire connection to the terminal for tool-free install.
Release wire: Insert 2mm bladed screwdriver into slot (no levering).
Wall Switches
MOMENTARY SWITCHES
Use momentary switches ONLY.
Must have a Center Off position.