User's Manual

RF Switch Interface, v1.0 Installation Guide

REPLACE THE BATTERY

Remove the battery from the holder and replace with a fresh, CR123A lithium battery.

Lithium batteries contain lithium metal compounds and should be recycled. Exchange lithium

batteries at the time of purchase or deliver an HHW collection site.

SPECIFICATIONS

Overall Dimensions: L: 1.82 in. W: 1.76 in. H: 1.13 in.

Electrical

Communicates with ESI RF devices, version 1, and later.

DC current, dry contacts.

Power: 3V Lithium battery, CR123A

Frequency: 2.4 GHz

Regulatory Compliance

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.

L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)

l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en

compromettre le fonctionnement.

This Class B digital apparatus complies with Canadian ICES-003.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of

the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's

authority to operate the equipment.

FCC ID: P7RRFSWTINTRFC

IC: 7206A-RFSWTINTRFC

Disclaimer

Information in this document is subject to change without notice. The manufacturer does not make any

representations or warranties (implied or otherwise) regarding the accuracy and completeness of this document and

shall in no event be liable for any loss of profit or any commercial damage, including but not limited to special,

incidental, consequential, or other damage.