Instruction manual

-13-
Section4-Initialsystemsetup
FIRECONFIG
MUSTFireconfig.exeisawindowsbasedapplicationprogramwhich beusedforinitialsystemsetup.
InstallFireConfig.exeontoyourWindowsXP /VistaPCharddriveorrundirectlyfromadatastickifrequired.
Useastraightthrough(notnullmodem)serialcablewitha9pinDtypemaleconnectorononeendandfemale
ontheother.IfusingalaptopwhichdoesnothaveasuitableserialportyouwillalsoneedaUSBtoSerialport
converter.
1. Checktheloopfittedboxesforallloopsfitted.(FortheED816A onlyloop1and2areapplicable.)
2. Click“Configure”forloop1.
3. Click“AddHead”andthenfillinthedetailsforthefirstaddressabledeviceontheloop.
4. Choosetheaddress,whichcanbe1to126.
5. Choosethename,whichcanbeamaximumof12characters.
6. Choosethezone,whichcanbe1to32. AdditionallyNoZonecanbespecified. Anydevicegoingintoalarm,
whichhasnothadazoneassigned,willoperatetheevacuatecommandandallsoundersandbeaconswill
operate. Additionallynodelaysorzoneisolatesareallowed.
ED816A AddressableFireandgasdetectionInstallationmanual8-9-08Rev-a