User's Manual Part 3

Micro Thermocouple Connector each (1 connector)
E31-0900-68
Micro Connector Socket, green pin
J31-0252-10
Micro Connector Socket, white pin
J31-0252-15
Micro Thermocouple Connector Crimping Tool
Y25-0312-10
Nano Thermocouple Connector Kit (2 connectors)
E47-6342-68
Nano Thermocouple #0 Phillips Head Screwdriver
G10-0128-10
1 inch Aluminum Tape Roll, 15 feet
G10-7594-18
Aluminum Tape Strips, .50 inch x 1 inch, 10 pieces total
M30-2686-74
Hi Temp Solder, SN10, 6 feet
G10-0041-00
Polyimide Film Tape, 108 feet, 5/8” Kapton
G10-0021-00
Polyimide Tape Strips, 20 pieces total
M30-2686-64
Adhesive Spray Accelerator
G10-0108-00
Clear Instant Adhesive
G10-0107-00
7. Service and Troubleshooting
7.1. General Service Information
This section covers maintaining and troubleshooting a M.O.L.E., Thermocouples, Power
Pack, Software, Wiring, and other parts of the system.
The following service and calibration instructions are for use by qualified
personnel only. Refer to the Safety>Operators Safety Information prior to
performing any service.
Service Troubleshooting:
Decide if the problem is with the M.O.L.E. Profiler Hardware, Communications, or
Software.
• If the problem occurs while attempting to log data, the Hardware may be faulty.
• If the problem occurs while attempting to communicate between M.O.L.E. Profiler
and the computer, the Communications links may be faulty.
• If the problem occurs while attempting to use a software function, the software may
be faulty.
Once it has been determined what item is causing the problem, refer to the appropriate
service section. Start at the top of the list and work your way down. If the problem is still
unresolved go to
Service>How to Get Additional Help.
7.2. SuperM.O.L.E.® Gold
This section describes problems that can occur with M.O.L.E. Profiler hardware.
Hardware Problems:
Wrong or erratic temperature readings: