User's Manual Part 3

When navigating through the wizard, the step list on the left uses a color key
to inform the user of the current step, steps that have been completed and
remaining steps.
Current Completed Remaining
3) Select the desired instrument from the dialog box. If there is none displayed, select
the Scan for Instruments command button to detect all connected instruments.
If the software does not detect a M.O.L.E. Profiler, using the communication
cable connect it to the computer and click the Scan for Instruments
command button to search again. M.O.L.E.® MAP software allows multiple
instruments to be connected to a computer at one time. Selecting the Scan for
Instruments command button will detect all instruments and display them in
the dialog box. If no instrument is detected the software displays all of the
Demonstration thermal profilers to select from.
4) Select the Next command button.
7) Set Recording Parameters such as the instrument name, recording interval, start
parameters and stop parameters. This step is where the user can also turn a
sensor channel ON or OFF, set the sensor location description and sensor type.
Refer to section Software>Menus>MOLE>Set Recording Parametersfor
detailed information for each setting.