User's Manual Part 3

must be done to the overlaid data run file prior to using the Overlay tool. Save that
data run file and use the Overlay tool again.
This command can be accessed on the Toolbar when the Profile Tab is active.
Overlay Button
5.5.10.5. Measure
The Measure tool is similar to the Slope tool except it measures the distance between any
two points on the Profile worksheet Data Graph. This tool adds a line labeled with the
distance values to the graph, and notes the change in X and change in Y (Delta X and
Delta Y) instead of the slope. »
This is available when in Engineer Mode.
To find the distance between two points:
1) On the Tools menu, click Measure.
2) Position the mouse pointer at a point on the curve.
3) Press and hold the left mouse button.
4) Drag the pointer to the end of the desired point on the curve.
5) Release the left mouse button when the pointer is at the desired location and a
slope line labeled with the change in X and Y appears on the Data Graph.