User's Manual Part 3

When downloading a data run from the M.O.L.E. Profiler, the default sensor
alignment can be specified in the Profile tab of the Preferences dialog box.
Refer to topic Software>Menus>File>Preferences>Profile for more
information.
5.5.9.6. Align Profile to Dimensions
If sensors are placed so they enter and exit machine zones at different times, the resulting
Data Plots lag behind one another. The Align Profile To Dimensions command
automatically aligns the (X) values specified in the Set Assembly Information command
for each Data Plot so they are aligned in time so they can be easily compared during
analysis.
This is available in both Engineer & Verify Modes.
To align profile to dimensions: