User's Manual Part 3

8) When finished, click the Save command button to complete the process.
When using the PTP® VP-8, the PTP® TX power must be turned OFF after
saving the data run by removing the On/Off Male Plug connector from the
Female On/Off Power connector.
Wireless RF communication tips (MEGAM.O.L.E.® & SuperM.O.L.E.® Gold 2):
RF signals come and go as either the M.O.L.E. Profiler moves through the oven or the
Transceiver is moved around like FM radio static as you drive in your car. Moving a few
inches in any direction can turn a low signal strength to high signal strength. This gets
worse as the Transceiver gets further from the M.O.L.E. Profiler, to a point where no
position works.
When setting up the Wireless RF system, the transceiver should be placed as close to
the machine as practical. A standard USB extension cable can be used to move the
Transceiver closer to the machine or up and away from metal or other interference
objects.
Typically if the Transceiver is 3 meters [10 feet] away from the M.O.L.E. Profiler in a
machine any location in the room, reception should be fine. Reception is also often a bit
better when the Transceiver is perpendicular to the direction of travel through the
machine. Metal objects such as carts, walls, or other equipment in the room will impede
transmission.