User's Manual Part 2

used to save a Target 10 specification if any adjustments have been made, or
creating a new one based off of an existing Target 10 specification.
If a different Target 10 specification is saved with a data run, it does not affect
the original Target 10 specification associated with the data run when using
the OK button on the MEGAM.O.L.E.® or V-M.O.L.E.® profilers.
 Assembly Image: This is a thumbnail image of the assembly product associated
with the currently displayed data run. To view the sensor locations, right-click over
the image and select the Enlarge command. When in Engineer mode the user
has the ability to set the sensor locations. When in Verify mode, the sensor
locations can only be viewed.
5.4.5. SPC Page Tab
The SPC Page Tab displays the specified parameters flagged on the Spreadsheet Page
Tab in SPC X-Bar and R charts. Refer to topic Software>Page
Tabs>Spreadsheet>SPC Flags for more information.
This is available when in Engineer Mode.
SPC Page Tab features:
 Menus and Toolbar buttons
 X-Bar Chart

R Chart

Statistics box