User's Manual Part 1

1.4. Terms Used
In 1986 ECD introduced our original Thermal Profiling instrument called the M.O.L.E.®
(Multichannel Occurrent Logger Evaluator). Over the years ECD has produced
several models of the M.O.L.E.® for use in a wide variety of applications. In this Users
Help System, we may refer to all of our Thermal Profiling instruments as the M.O.L.E.®
Profiler.
The M.O.L.E.® Profiler is a registered trademark of ECD.
The following statements describe special terms that will be used in this Users
Help System:
Informs the user that the note includes important information.
Informs the user that the note includes a handy tip.
Informs the user of an equation used.
Hardware Terms:
Informs the user that the note identifies conditions or practices that could result
in damage to the equipment.
Informs the user that the note identifies conditions or practices that could result
in personal injury or damage to property other than the equipment.
• Thermocouple, may be referred to as T/C.
Software Terms:
• Page Tab Views, the individual page tabs in the MEGAM.O.L.E.® software.
• Data Set, multiple data runs saved as individual .XMG files into the open working
directory.
• Data Run, the data uploaded from the M.O.L.E. Profiler and saved as an .XMG file
into a working directory. This data run is displayed on the Data Graph as a Profile.
• Modes, a set of page tabs, menus, toolbars, and shortcuts that are grouped and
organized so that the user can work in a task-oriented environment.