User's Manual Part 1

analyzes the most recent data run to verify the Target 10 Specifications applied to
the previously selected data run.
Only the MEGAM.O.L.E.®, V-M.O.L.E.® and SuperM.O.L.E.® Gold 2 are
equipped with the OK button. When using the SuperM.O.L.E.® Gold please
skip the previous step.
20) Connect the M.O.L.E. Profiler to the computer and click the Next command button.
21) Select the desired data run and then click the Next command button to read the
data run from the M.O.L.E. Profiler.
This step of the wizard allows the user to remove a selected data run from the
M.O.L.E. Profiler by either selecting the Delete After Reading check box or
selecting the Delete command button and removing it before downloading.
This feature is not available for the SuperM.O.L.E.® Gold Thermal Profiler as it
does not have the ability to store more than one data run.
• When using a SuperM.O.L.E.® Gold Thermal Profiler, prior to reading the data
run, the software prompts the user to select the sensor type for the active
channels. When finished select the OK command button to proceed.