User's Manual Part 1

11) Attach sensors to a test assembly. Make sure to connect them to the same
locations that were used when creating the verification specification file. If the
same test assembly is being used that was used to create the verification
specification file, no thermocouple attachment will be required.
When soldering a T/C sensor to a component with high temperature solder,
use Kester SN10 (or equivalent) for 183°C eutetic solder or Kester SN5 (or
equivalent) for lead free soldering. Kapton® tape, aluminum tape and
Temprobe™ can also be used to hold T/C wire to the test assembly.