User's Manual Part 1

4.3. Operation - Verify
This section guides the user through a typical verification process. Portions of this section
require referral to some software sections of the Users Help System for additional
information.
The M.O.L.E.® MAP software is designed to be used with the ECD
MEGAM.O.L.E.®, V-M.O.L.E.®, SuperM.O.L.E.® Gold, SuperM.O.L.E.® Gold
2 and PTP® VP-8 Thermal Profilers. Images used in software sections of
this Users Help System typically refer to the SuperM.O.L.E.® Gold 2.
Using the Engineer mode a Target 10 specification can be created by using a data run
and recipe or a data run and recipe already developed. Once this file has been created, it
can be used to verify a process or machine performance along with the M.O.L.E. Profiler
and/or OvenCHECKER™. Refer to topic Optional
Accessories>Products>OvenCHECKER™ for more information on the
OvenCHECKER™.
After the hardware is setup and the software is installed, use the following steps to verify
a process using a M.O.L.E. Profiler.
Step 1: Create Target 10 File
This is available when in Engineer Mode.
1) On the File menu, click New. A message box appears with the five workflow
wizard options.
2) On the Start dialog box, click the Create T-10 command button and the workflow
wizard appears.
3) Select the instrument type that will be used to verify the process.