User's Manual Part 1

It is highly recommended that protective gloves are used when retrieving the
thermal barrier from the oven and when opening the thermal barrier.
4) As the test assembly and M.O.L.E. Profiler emerge from the machine, carry the
test assembly with sensors attached and the M.O.L.E. Profiler in the Thermal
barrier to a table or flat surface.
If a sensor is removed before the M.O.L.E. Profiler has stopped collecting
data, the data for that channel might become distorted.
5) Open the Thermal barrier and if the Activity LED is still flashing this means the
M.O.L.E. Profiler is still recording and it must be stopped.
When using a SuperM.O.L.E.® Gold Profiler, press and Hold the Start/Stop
button until the Activity LED turns OFF. Pressing the Start/Stop button briefly
will restart the data collection process and erase all the data in memory.
6) Remove the M.O.L.E. Profiler from the Thermal barrier. Handle it carefully, as the
case may still be warm.
7) Disconnect the sensors from the M.O.L.E. Profiler and place it near the computer.
Step 3: Read Data Run
1) Restore the software and click the Finish command button to read the data run
from the M.O.L.E. Profiler.
This step of the wizard allows the user to remove a selected data run from the
M.O.L.E. Profiler by either selecting the Delete After Reading check box or
selecting the Delete command button and removing it before downloading.
This feature is not available for the SuperM.O.L.E.® Gold Thermal Profiler as it
does not have the ability to store more than one data run.