User's Manual Part 1

Step 2: Perform Data Run
1) Place the M.O.L.E. Profiler in the appropriate thermal barrier making sure the
Thermocouple and/or Sensor wires are not damaged.
Never permit the M.O.L.E. Profiler to exceed the absolute maximum
warranteed internal temperature, as permanent damage may result. The
warranty will not cover damage caused by exceeding the maximum specified
internal temperature.
2) After the oven stabilizes, turn the M.O.L.E. Profiler ON and press the record
button.
When using a SuperM.O.L.E.® Gold press the Start/Stop button on the M.O.L.E.
once to initiate data collection. When the M.O.L.E. is “ON”, the Activity light will
flash quickly and then flash at the log interval for the duration of the experiment.
The record button will need to be pressed even if the M.O.L.E. profiler is
configured to start if the start parameters Trigger Temperature or Points
Delay are configured.
3) Pass the thermally protected M.O.L.E. Profiler and test assembly through the
machine.