User's Manual Part 1

12) When finished, click the OK command button to accept or Cancel to return without
making any changes.
13) Click the Next command button.
14) Attach sensors to a test assembly.
When soldering a T/C sensor to a component with high temperature solder,
use Kester SN10 (or equivalent) for 183°C eutetic solder or Kester SN5 (or
equivalent) for lead free soldering.
15) Unwind the sensor leads and attach the connectors to the M.O.L.E. Profiler. Make
sure to connect them to the same channel(s) that were configured in the wizard
workflow. For example, if configuring the M.O.L.E. Profiler to have Channels 1
through 5 active, be sure the sensors are attached to the same five channels.
Kapton® tape, aluminum tape and Temprobe™ can also be used to hold T/C
wire to the test assembly.