User's Manual Part 1

4.2. Operation - Fresh Start
This section guides the user through a typical collection process. Portions of this section
require referral to some software sections of the Users Help System for additional
information.
The M.O.L.E.® MAP software is designed to be used with the ECD
MEGAM.O.L.E.®, V-M.O.L.E.®, SuperM.O.L.E.® Gold, SuperM.O.L.E.® Gold
2 and PTP® VP-8 Thermal Profilers. Images used in software sections of
this Users Help System typically refer to the SuperM.O.L.E.® Gold 2.
The M.O.L.E. Profiler is dependent on the software to control how it collects and interprets
data. Several kinds of data runs may need to be performed to achieve desired
information, or the same data run may be performed repeatedly over time to monitor one
process. Either way, an data run will need to be setup at least once.
After the hardware is setup and the software is installed, use the following steps to
perform an experiment using a M.O.L.E. Profiler.
This procedure uses the "Fresh Start" wizard for the typical data run process.
Step 1: Set MAP information
1) Start the software by double clicking on the program icon.
2) Connect the M.O.L.E. Profiler to the computer. Refer to topic
Basics>Setup>Communications Setup for more information.
When the information is being sent to a SuperM.O.L.E. Gold Profiler the
Activity LED will illuminate indicating that it is communicating with the
computer properly.
3) Make sure the M.O.L.E. Profiler Power Pack battery is fully charged. When a
M.O.L.E. Profiler is selected, the software status bar displays the current battery
voltage. Refer to topic Software>Features>Status Bar for more information.