User's Manual Part 1

4.1.2.2.1. Wireless RF Option Setup
To connect the wireless RF option:
Prior to wireless RF communication, the M.O.L.E. Profiler must first be
connected to a computer through the USB port. This allows the software to
register the serial number of the M.O.L.E. Profiler. Registering the serial
number ensures that other M.O.L.E. RF transmissions in close proximity to
each other will not interfere preventing others from controlling your M.O.L.E.
Profiler without your consent. (Refer to Communications Setup for more
information)
1) Insert the Wirless RF Transceiver into an available USB port and the Antenna to
the M.O.L.E. Profiler. The first time the Transceiver is connected to a computer,
the drivers will automatically be installed. The operating system displays the
installation status on the taskbar.
The M.O.L.E. Profiler is designed to work with the included antenna ECD P/N:
E51-0386-11 only. Never make any changes or modifications to the Wireless
RF components. Such changes are not expressly approved by ECD and could
void the user's authority to operate the equipment.