User's Manual Part 1

4.1.2. Communications Setup
Prior to operation the M.O.L.E. Profiler must be configured to properly communicate with
the M.O.L.E.® MAP Software.
The M.O.L.E.® MAP software must be installed prior to communications
setup. (Refer to Software Installation for more information).
4.1.2.1. SuperM.O.L.E.® Gold
To connect the M.O.L.E. Profiler:
The M.O.L.E.® MAP software must be installed prior to communications
setup. (Refer to Software Installation for more information).
1) Locate the computer Interface cable and plug the 9-pin connector into a computer
COM port and the other end into the M.O.L.E. Profiler Data Port.
If no Serial port exists, use the included USB adaptor to connect the
interface cable to the computer.
2) After the computer interface cable is connected to a computer, the Communication
(COM) port must be configured in the software to match the same COM Port as the
computer so they can communicate.