User's Manual Part 3

♦297♦ MEGAM.O.L.E.® Help System Guide
5.5.6.3. Adjust Zones
This command allows the user to manually adjust the displayed machine zones on the
Data Graph. To use this command a machine must be selected and displayed. Refer to
topic Software>Menus>Machine>Set Machine Information.
To adjust zones:
1) One the Machine-Oven menu, click Adjust Zones to activate. A check mark
appears to the left of the command indicating the software is in Adjust Zones
mode.
2) Position the mouse pointer over a desired machine zone line.
3) Click and hold the left mouse button to drag it left or right releasing the mouse
button when the machine zone line is at the desired location.
4) Lock the settings by selecting the Adjust Zones command again. This removes
the check mark next to the command indicating the software is not in Adjust
Zones mode.