Datasheet

EA uniTFT Vorläufig
PATH DETAILS, FILES AND FORMATTING
PATH DETAILS
There are two ways of indicating the path. In absolute and relative terms, respectively.
Designation Example
Absolute path details </Ordner/Unterordner>
Relative path details <.../Unterordner>
The absolute path details should be used to work with files outside the project path set. The project path, which is
defined by the command XPS serves to simplify matters. It is not necessary to specify the superordinate direc-
tories. By entering “P:” prior to specifying the path, the project paths are automatically added.
If a file is to be accessed in the project folder “picture” set, that can be done absolutely or relatively, as shown in
the following example:
Absolute path details: </Ordner/Ordner/Ordner/Projekt/picture/Test.epg
Relative path details: <p:/picture/Test.epg → The project path has been set as " #XPS </Ord-
ner/Ordner/Ordner/Projekt>"
When specifying the path, upper and lower case are to be taken into account.
One more simplification::
There is a series of default folders that are automatically created in the project folder and may
NEVER be changed, as, otherwise, command parameters that automatically access these folders no
longer work!
This folder structure is defined as follows:
Example:
#PPP1, "Test"; 100, 100
With this command, the “test” image is shown on the display at the position 100,100.
An alternative programming step would be: #PPP1, <P:/picture/Test.epg>, 100, 100 .
Technische Änderung vorbehalten.
Wir übernehmen keine Haftung für Druckfehler und Applikationsbeispiele..
Seite 12