Datasheet

EA OLEDL128-6
Technische Änderung vorbehalten. Seite 4
Wir übernehmen keine Haftung für Druckfehler und Applikationsbeispiele
DATA TRANSFER 4-WIRE SPI (8 BIT)
Data transmission for SPI is
unidirectional, that means that
data can only be written, there’s
no data read option. Selection
for writing data or command is
done with the D/C line. A busy
check is not necessary at all.
Clock rate may be up to 10
MHz. Data transmission is
based on SPI mode 3, MSB
first. For more details please
refer to the controllers data
sheet SSD1309.
DATA TRANSFER 4-WIRE SPI (9 BIT)
Data transmission for SPI is
unidirectional, that means
that data can only be written,
there’s no data read option.
Selection for writing data or
command is done with the
first bit of the 9 bit data
transfer. A busy check is not
necessary at all. Clock rate
may be up to 10 MHz. Data transmission is based on SPI mode 3, MSB first (9 bit). For more details please
refer to the controllers data sheet SSD1309.
DATA TRANSFER I²C
The I²C mode provides a bi-directional data transmission: That means that data can be written and read. With
the pin SA0 the I²C address can be changed, so up to 2 displays may be driven on 1 bus. The clock rate may
be up to 400 KHz. Please make sure when defining the pull-up resistors that the internal resistance of the
display is 600..1000 . This affects the low level when reading data and ACK bit.
Attention: When reading data, after the command for page- or column address there need to be a dummy
read (discard the first byte).
Control byte: C
o
(Continuation bit) = 0  Display data do follow; 1  refer D/C bit