Datasheet

EA eDIPTFT70-A
Page 34
ELECTRONIC ASSEMBLY reserves
the right to change specifications
without prior notice. Printing and
typographical errors reserved.
NOTES ON HANDLING AND OPERATION
- The module can be destroyed by polarity reversal or overvoltage of the power
supply; overvoltage, reverse polarity or static discharge at the inputs; or short-
circuiting of the outputs.
- It is essential that the power supply is switched off before the module is
disconnected. All inputs must also be deenergized.
- The display and touch screen are made of plastic and must not come into contact
with hard objects. The surfaces can be cleaned using a soft cloth without solvents.
- The module is designed exclusively for use in buildings. Additional measures have to be taken if it
is to be used outdoors. The maximum temperature range of -20 to +70°C must not be exceeded. If
used in a damp environment, the module may malfunction or fail. The display must be protected from
direct sunshine.
SPEZIFICATION AND CHARACTERISTICS
Characteristics
Value Condition min. typ. max. Unit
Operating Temperature -20 +70 °C
Storage Temperature -30 +80 °C
Storage Humidity < 40°C 90 %RH
Operating Voltage 4.9 5.0 5.1 V
Input Low Voltage -0.5 0.3*VDD V
Input High Voltage Pin Reset only 0.9*VDD VDD+0.5 V
Input High Voltage except Reset 0.6*VDD VDD+0.5 V
Input Leakage Current Pin MOSI only 1 uA
Input Pull-up Resistor 20 50 kOhms
Output Low Voltage 0.7 V
Output High Voltage 4.2 V
Brightness (white)
w./o. Touch 480 cd/m²
with Touch 400 cd/m²
Output Current 20 mA
Power Supply
Backlight 100% 690 1000* mA
Backlight off 200 500* mA
ATTENTION
handling precautions!
*) Peak, if a sound is played with full volume.