Lightweight Upright VACUUM CLEANER Household Type Owner’s Guide Z400 Series IMPORTANT For any advice and to order filters and accessories on your cleaner, please telephone Customer Care 08706 055055 Index Important Safeguards ............... 2 Service Information ................... 4 Parts & Assembly .................. 5-6 Use & Dust Cup ..................... 6-7 Brush Roll & Blockages ............ 8 Guarantee .............................. 10 www.electrolux.co.
IMPORTANT SAFEGUARDS When using an electric appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER WARNING To reduce the risk of fire, electric shock, or injury: • Do not use outdoors or on wet surfaces. • Do not leave vacuum cleaner when plugged in. Turn off the switch and unplug the electrical cord when not in use and before servicing. • Do not allow to be used as a toy.
BEFORE YOU START CHECK THE VOLTAGE First check the voltage shown on the data plate (see rear view) to make sure that the cleaner is of the correct voltage for your electricity supply. If it is not, do not use the cleaner but refer back to your dealer. CONNECTING TO YOUR ELECTRICITY SUPPLY Permanently connected to the cleaner is a mains supply (2-core) cable fitted with a non-rewirable plug incorporating a 5A fuse.
SERVICE Should you require service on your Electrolux cleaner, please telephone 08706 055055. Before requesting service, please check whether your problem is covered under Service Checklist (see below). SERVICE CHECKLIST • • • • • • If your cleaner will not operate, check the plug connection, plug fuse and mains fuse. Never allow the filter to become so clogged that it impedes the air-flow, thus reducing the cleaning efficiency of the machine.
Identify Parts 3 7 1 4 9 6 5 10 8 2 1. Body 2. Floor Nozzle 3. Handle 8. Stair Cleaning Hand Grip 9. Handle Button 10. Electrical Cord 4. On/Off Switch 5. Dust Cup Latch 6. Dust Cup 7.
HOW TO ASSEMBLE Loop Attach Handle 1. Locate the handle and body. Handle 2. Line the handle up with the hole in the top of the body. Flat side of handle and loop forward. 3. Push handle down into body while pressing button on back of the body. Handle will click into place. Body 4. There are two handle positions available. Handle all the way up and handle all the way down. Button 5. Button needs to be depressed to raise and lower the handle.
HOW TO MAINTAIN The instructions given in this booklet serve as a guide to routine maintenance. Keep the cleaner operating at top efficiency. Empty the dust cup after each use. NOTE: Turn off the power switch and unplug the electrical cord to service. Empty Dust Cup Hook Latch 1. Pull dust cup latch up. 2. Swing dust cup out from body and up off the dust cup hook on the body. 3. Leaving dust cup filter in the dust cup, shake contents of dust cup into a waste container.
HOW TO MAINTAIN (continued) Brush Roll NOTE: Turn off switch and unplug the electrical cord before inspecting brush roll. Long hair, thread, string, etc. can wrap around the revolving brush roll and result in reduced performance. To check brush roll for debris turn cleaner nozzle over and inspect for wrapped matter. Use scissors to cut debris from brush roll. Brush Roll How to Check for Blockages NOTE: Turn off switch and unplug the electrical cord before checking for blockages.
Guarantee This guarantee is in addition to your statutory and other legal rights. This product is for household use only. Electrolux products are carefully designed, manufactured, tested and inspected and, in consequence, we undertake to replace or repair any part found to be defective in material or workmanship, within one year of delivery to the original purchaser, free of charge.
Part No.
