Specifications
45
Procedure for use
Reset scale to zero
Check that ”RESET
SCALE TO ZERO” is high
-
lighted.
If it isn’t...
Press
c or b as
required to highlight ”RE
-
SET SCALE TO ZERO”.
Press SELECT.
4778
4779
Reset scale to zero
”Reset weighing equipment” is used to make the
weighing equipment display 0 when the machine
has no load in it.
If your attempt to reset the weighing equipment
fails at this point, you will see an error message
equivalent to: “FAILED. PRESS SELECT” on
the display. For troubleshooting, see the sec-
tion “Fault-finding, weighing equipment” in the
machine manual.
This screen shows that the
weighing equipment has
been reset to zero.
Press SELECT.
For machines with weighing equipment installed only!
Please note:
The machine must be unladen when you use this
function, i.e. no water or wash load in the drum.
Please note:
After a power-cut, the weighing equipment will
always display 0, no matter what the actual load
in the drum. In this event you will have to use the
“Reset scale to zero” function.