Specifications

English 5
Connection
terminals
Display
Self-adhesive magnet strip for
permanent installation
Battery charger
Handle
Flexible bumper
Filter lid
lock button
Terminals for
connection
to charger
Product Description
Roller
Drive wheel
Rating plate Roller cover
lock button
Trilobite
Trilobite navigates using ultrasound and uses infrared light to
detect differences in surface level. During Wall Mapping, it receives
information about the size of the room.Wall Mapping is the basis
for the estimated duration for independent vacuuming in Normal
vacuuming mode.
NOTE:Trilobite is not fully charged upon delivery. Before
using it the first time, connect it to the battery charger (see page 7).
A full battery charge takes approximately two hours.
Battery charger
Put the battery charger on the floor, plug it into a nearby outlet
and place it with its rear side facing the wall.Allow a free space of
8 inches on the right side of the charger.When Trilobite has
completed Normal vacuuming, it returns to the charger.The
batteries are then charged, and it is ready for more work.
Magnetic strips
The magnetic strips serve as “virtual walls” and are important for
correct operation. Use them to block door and wall openings, as
well as differences in level of less than 4 inches (see page 8).
Be sure to block differences in level of less than 4 inches with the
magnetic strips. If you fail to do so, Trilobite could fall over the edge
and cause injuries or damage to property.
A self-adhesive magnetic strip that has been pulled back up has
less adhesive capability.We therefore strongly recommend that
you permanently mount all necessary strips. Never re-use the
adhesive of a magnetic strip in any application where safety is
important. Note that the magnetic strip is not a safety device
unless it is fastened to the floor; that applies to both the self-
adhesive and the wider strip. If you nonetheless choose to let a
strip lie unfastened on the floor, make sure that the side with the
adhesive (covered by the protective paper backing) is face down!
For the wide magnetic strip, the flat side (marked with two
parallel grooves) should be facing downwards.
Use a pair of scissors or a knife to trim magnetic strips to the
correct length. See page 8 in the user instructions to see how a
magnetic strip should be fitted.
NOTE: Magnetic strips left partially coiled, may attract
Trilobite when it is seeking the battery charger – uncoil the
magnetic strip completely.
Emptying the dust collector
Empty the dust collector when the Dust Collector icon shows in
the display. Be sure to empty the dust collector, even if it is not
completely full.The light indicator may be displayed if a filter is
blocked.
Movable, wide magnetic
strip for temporary use