MANUAL World Fridge RM 4203 Deutsch Seite 1 Svenska Sida 31 English Page 7 Dansk Side 37 Français Page 13 Norsk Side 43 Italiano Pagina 19 Nederlands Pag. 49 Español Pagina 25 Suomi Sivu 55 Typ C60 / 70 821 2652-01 T.B.
OPERATING AND INSTALLATION INSTRUCTIONS FOR DOMETIC REFRIGERATORS. INTRODUCTION CONTENTS We are pleased that you have chosen this refrigerator and hope you will derive much satisfaction from using it, but first a few well-meant words of advice: OPERATING INSTRUCTIONS . . . . . . . . . . . . . . . . . . 8 CONTROLS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 It is important to read through these instructions carefully before beginning to use the refrigerator.
OPERATING INSTRUCTIONS 12 V Operation CONTROLS Only operate your refrigerator on 12 V when the engine of the vehicle is running - otherwise your battery will soon be discharged. The refrigerator can be run on either 230 V, 12 V or LP gas. Changing between these modes of operation is carried out by means of the controls of the control paner shown in fig 3. ● If applicable, turn off the gas operation ● Depress the voltage selector (A) to position 12 V.
Most kinds of frozen food can be stored in the frozen food compartment for about a month. This period of time may vary, however, and it is important to follow the instructions on the individual packings. TURNING OFF THE REFRIGERATOR ICE-MAKING ● Set the voltage selector (A), fig. 3, to 0. If the refrigerator is not to be used for some time: ● Shut off any on-board valve in the gas line to the refrigerator. ● Set the gas valve (C) to ●.
installation as well as the connect flue oulets are to be checked every two years by an expert (this has to be arranged by the person responsible). mid . . . . . . . . . . . . . . . . . . . . . . .0,24 kg min . . . . . . . . . . . . . . . . . . . . . . .0.16 kg Cooling medium . . . . . . . . . . . . . .
For best performance also at high ambient temperatures there must be a free air circulation over the cooling unit at the rear of the refrigerator. LP GAS CONNECTION The refrigerator is designed for operation on liquified petroleum gas (LPG), the pressure of which must be: The refrigerator is designed for a free-standing installation and the clearance to side walls etc., should be at least 5 cm (2''). ● for Butane type LPG 28 mbar ● for Propane type LPG 37 mbar Check that this is stated on the data plate.
A flexible tube/hose, of max 1,5 m length approved for LPG is connected to the threaded nipple (J) of fig. 6. Its other end is connected to the reducing valve of the gas bottle as shown in 8 ig. 9 or to an easily accessible gas shut off valve which forms a part of the fixed gas installation of the building. The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured red. WARNING - THIS APPLIANCE MUST BE EARTHED.
