r CONTENTS Warnings installation . Unpacking Positioning . Wateriness . Water drainage . Leveling . Elar:mcamonnectnon Getting to know your machine Control pane Washing hints . Wash care symbols Energetic wash cycles . Gentle wash cycles . . Use of detergent and additives Using your machine . Washing 4 kg of white cotton at 95°C . Washing 2 kg of synthetic fabrics at 40°C . Maintenance and cleaning . Descaling, after each wash, external cleaning .
IMPORTANT INFORMATION it is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred {o another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings have been provided in the interest of safety.
INSTALLATION Unpacking Before strafing the machine up, the packing must be removed as follows., You are advised {o keep all the packaging for re-use in case the machine is to be transported again. Unscrew and remove the rear right bolt (using a spanner). Lay the machine gently on its back, making sure that the hoses are not squashed. Remove the polystyrene block from the bosom of the machine. Carefully slide out the right polythene bag (1), removing it toward the center of the machine.
INSTALLATION Water drainage I you intend the drain hose from the machine to empty info a sink, make sure that the sink is empty and that the plug hole is not blocked. if the machine is permanently plumbed in, hook the end of the hose into a standpipe installed for the purpose. The standpipe must have an internal diameter of at least 40 mm (1 1/2") in order that there is an air gap between the drain hose and the standpipe.
Electrical connections WARNING: THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed, If the plug that is fitted to your appliance is not suitable for your socket outset, it must be cut off and the appropriate plug fitted. Remove the fuse from the cut off plug. The cut off plug should then be disposed of to prevent the hazard of shocks in case i should be plugged into a 13 Amp socket in another part of your home.
GETTING TO KNOW YOUR MACHINE Control panel s, [ra—" same accrue on . whew B " ELSE ASH Detergent dispenser drawer 5 Quick wash button Symbols By depressing this button on programmed A-B-C and H the wash time will be reduced by approx. 20 mind. Thesis LU Rewash suitable only for garments which are lightly soiled. ) wash & Fabric softener 2 Pull out programmer guide 3 Spin speed selector knob Push to release the button.
Washing hints Do NOT overload the machine. Weigh the laundry the first few times you use the appliance. The average weights of the most comment items are listed below as a guide: 1000g=1kg Sheet 700-1000g Pillow case 100-200g Tablecloth 400-500 g Serviette 50-100g Tea towel 70-120¢g Linen hand towel 100-1509 Toweling hand towel 150-250 ¢ Toweling bath towel 700-1000 g Bath robe 1000-1500 g Man's shirt 200-300g Aron 150-200 ¢ * Load the laundry loosely alternating large items with small ones.
Wash care symbols The familiar wash code symbols which are found on the care labels in most clothes are disappearing ad a new set is introduced. The change is due to changes in fabrics and detergents and because people are tending to use fewer programmed and mix fabrics in one goad. The change brings the codes into line with the labeling used in the rest of Europe.
Programmed for cotton and linen Recommended load: max. COMPARTMENTS DEGREE o PROGRAMMER PROGRAMMED OF SOIL TOUSE(® if DIAL POSITION DESCRIPTION required} Rewash at 40 °C REWASH Heavy R Draining and short spin Wash at 95 °C WHITES Normal A Rinses Spin WHITES ) Prolonged wash at 60 °G ECONOMY Light A+E oS Wash at 60 °C FAST 9 COLOREDS Normal B Wash at 40 °C NON-FAST.
Programmed for synthetics, delicate and wool Recommended load: max. 2 kg (4.5 Ib}; wool max. 1 kg (2.2 i) COMPARTMENTS DEGREE o PROGRAMMER PROGRAMMED TOUCHE (B it DESCRIPTION OF SOIL required) DIAL POSITION Wash at 50 °C M Normal H Rinses Short spin (7 Wash at 40 °C DELICATE Normal J Rinses = Short spin () WOOLENS at40°C & Normal K Rinses Short spin Wash SEWERS: ER Light L Rinses Short spin Rinses, with fabric softener, RINSES M if required. Short spin () SOFTENER N ?ins.
Use of detergent and additives Choosing The Right Detergent Always use a low lather powder or liquid. This is important as too much lather prevents the articles from being properly cleansed and may damage the machine.
USING YOUR MACHINE WASHING 4 KG OF WHITE COTTON AT 95°C Suppose you have 4 kg of normally dirty laundry to wash, It is white cotton and is suitable for high temperature washing. 1 Load the laundry Open the door by pulling the catch outward. Load the items one at a time and close the door. Pull out the detergent dispenser drawer from the control panel.
WASHING 2 KG OF SYNTHETIC FABRICS AT 40°C Suppose you have 2 kg of synthetic fabric laundry to wash. They are rather delicate fabrics and should not be washed at a high temperature. 1 Load the laundry Open the door by pulling the catch outward. Load the items one at a time and close the door. Pauli out the detergent dispenser drawer from the control panel. Measure out the amount of detergent required and pour into the main wash compartment.
MAINTENANCE AND CLEANING Before any maintenance or cleaning is carried out you must DISCONNECT the appliance from the electricity supply. Descaling The water we normally uss contains lime. It is & good idea to periodically use a water softening powder in the machine. Do this separately from any laundry washing, and according 1o the softening powder manufacturer's instructions. This will help to prevent the formation of dime deposits. After each wash Leave the door open for a while.
Cleaning the filter The water drain filter A clean filter is important for the correct functioning of the machine, and should therefore be cleaned after every wash. Open the filter door and place a container underneath to catch any spill{ age. I the filter is blocked i / and the machine is unable to drain you will need 1o drain the water manually from the machine at this stage. To do this, — unhook the drain hose from the standpipe or sink and hood the end of the hose over a bow! on the floor.
SERVICING Before contacting your local Electrolyte Service Center, please make the following checks: The machine does not start up » The has not been depressed u The door is not closed properly m No water is entering the machine (see: the machine does not fill) The machine does not fill = The water taps are not muted on = The water supply has been disconnected.
ELECTROLYTE GUARANTEE CONDITIONS We, Electrolyte, undertake that if within 12 months of the date of the purchase this Electrolyte appliance or any part thereof is proved to be defective by reason only of tautly workmanship or materials, we will, tour option repair or replace the same FREE OF ANY CHARGE for labor, materials or carriage on condition that: ® The appliance has been installed correctly and used only on the electricity supply stated on the rating piste.
