Operating instructions

the spin speed by means of button and then depress
Start/Pause .
Important! If you accidentally press the button
more than once, the display will show three blinking
dashes. To drain the water, select any washing
programme by means of the button, then press
three times in order to select the DRAIN position
(only the DRAIN light will remain lit).
6 OPTION button
Press these buttons to select the following options:
• PREWASH (Vorwäsche/Prélavage): select this
option if you wish your laundry to be prewashed
before the main wash (not available for wool
and hand wash programmes).
The prewash ends with a short spin at 650 rpm in
programmes for cotton and synthetic fabrics,
whereas in the programme for delicate fabrics the
water is only drained.
• ECO: this option can be selected for cottons and
synthetics lightly or normally soiled with a
temperature of 40°C or higher.
Furthermore the washing temperature will be
reduced automatically and the washing time will be
prolonged.
• SUPER RINSE (Spülen+/Rinçage+): this option
can be selected with all programmes except the
wool and hand wash programmes. The
machine will add some additional rinses to the
selected programme. This option is recommended
for people who are allergic to detergents, and in
areas where the water is very soft.
7 Display
The following pieces of information are shown on the
display:
• Three blinking dashes, when a programme is
cancelled by means of the button.
The three blinking dashes will also appear when you
press the button to switch the machine on, if the
previously selected cycle has been erased.
•
Duration of washing programme in hours
and minutes, after you have selected a
programme.
While the programme is running (after you have
pressed the button), the displayed time value
decreases by one unit every minute.
• The washing machine has stopped with water in
the tub, at the end of a programme with the
RINSE HOLD option: this is indicated by a
flashing zero.
• The washing machine has completed the
programme: this is indicated by a blinking zero.
The zero will reappear when you switch the
washing machine on, unless the previous
programme has been erased by means of the
button.
Important!
The first time you use the washing machine,
when you switch it on, it may display a blinking zero.
This is due to the fact that the washing machine has
performed a washing cycle during the manufacturer’s
inspection tests, and this cycle has not been erased
after its completion.
0
2.05
---
78
Downloaded From WashingMachine-Manual.com Manuals