user manual Freezer EUF19200W
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.
electrolux 3 • It is dangerous to alter the specifications or modify this product in any way. Any damage to the cord may cause a short-circuit, fire and/or electric shock. Warning! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel. 1. Power cord must not be lengthened. 2. Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or damaged power plug may overheat and cause a fire. 3.
electrolux by a qualified electrician or competent person. • This product must be serviced by an authorized Service Centre, and only genuine spare parts must be used. Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be dis- carded together with the urban refuse and rubbish.
electrolux 5 Repeat the whole procedure from closed door until the desired setting is achieved. The temperature will stabilize within 24 hour. Important! If the yellow indicator light is yellow after the temperature change, switch off Action Freeze by pushing the Control lever for 3 seconds. Action Freeze function You can activate the Action Freeze function by pushing the Control lever to Action Freeze position. Wait for some seconds. The yellow indicator light will light up.
electrolux protrude until load limit stated on the side of the middle section Important! In the event of accidental defrosting, for example due to a power failure, if the power has been off for longer that the value shown in the technical characteristics chart under "rising time", the defrosted food must be consumed quickly or cooked immediately and then re-frozen (after cooling).
electrolux 7 Care and cleaning Caution! Unplug the appliance before carrying out any maintenance operation. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. Periodic cleaning The equipment has to be cleaned regularly: • clean the inside and accessories with lukewarm water and some neutral soap. • regularly check the door seals and wipe clean to ensure they are clean and free from debris.
electrolux What to do if… During operation of the appliance some smaller but annoying trouble can often occur, which does not require calling a technician out. In the following chart information is given about them to avoid unnecessary charges on service. Important! The operation of the appliance goes with certain sounds (compressor and Problem The appliance is noisy. circulating sound). This not means a trouble, but a normal operation.
electrolux 9 Problem Possible cause Solution Large quantities of food to be fro- Insert smaller quantities of food to zen were put in at the same time. be frozen at the same time. The appliance does not operate. The appliance is switched off. Switch on the appliance. The mains plug is not connected to the mains socket correctly. Connect the mains plug to the mains socket correctly. The appliance has no power. There is no voltage in the mains socket.
electrolux not be positioned below overhanging wall units. If the cabinet is placed in a corner and the side with the hinges facing the wall, the distance between the wall and the cabinet must be at least 150 mm to allow the door to open enough so that the equipment can be removed. The ventilation space can be: • directly above the appliance • behind and above the top cupboard. In this case, the space behind the top cupboard must be at least 50 mm deep. 2.
electrolux 11 3-4 mm drift or drill into them. Install the handle. Install the hole covers provided within the accessory bag. 5. Unscrew the lower hinge. Change the position of the pin and buffert. Screw the lower hinge on the opposite side. 9. Put the cabinet in position. Warning! Reposition, level the appliance, wait for at least four hours and then connect it to the power socket. Do a final check to make sure that: • All screws are tightened. • The magnetic seal adheres to the cabinet.
www.electrolux.
