user manual Dishwasher ESI 66010
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.
electrolux 3 Installation • Make sure that the appliance is not damaged because of transport. Do not connect a damaged appliance. If necessary, contact the supplier. • Remove all packaging before first use. • A qualified and competent person must do the electrical installation. • A qualified and competent person must do the plumbing installation. • Do not change the specifications or modify this product. Risk of injury and damage to the appliance.
electrolux Control panel 1 2 3 4 5 6 On/off button Programme selection buttons Delay start button Digital display Indicator lights Function buttons Indicator lights Programme-in-progress – Comes on when you select a washing programme. – Stays on for all the duration of the washing programme. – Goes off at the end of the washing programme. End-of-programme Comes on when the washing programme is completed. Multitab Comes on when you activate the multitab function. Refer to 'Multitab function'.
electrolux 5 Indicator lights Rinse aid 1) Comes on when it is necessary to fill the rinse aid. Refer to 'Use of rinse aid'. 1) When the salt and/or rinse aid containers are empty, the related indicator lights do not come on while a washing programme operates. Programme selection buttons With these buttons you can select the washing programme. Press a programme button, the related indicator light comes on. Refer to 'Washing programmes' chapter for more data about the washing programmes.
electrolux Setting the water softener The water softener removes minerals and salts from the water supply. Minerals and salts can have bad effect on the operation of the appliance. Water hardness is measured in equivalent scales: • German degrees (dH°). • French degrees (°TH). • mmol/l (millimol per litre - international unit for the hardness of water). • Clarke. Adjust the water softener to the water hardness in your area. If necessary, contact your local water authority.
electrolux 7 Use of dishwasher salt Caution! Only use dishwashers salt. Types of salt that are not applicable for dishwashers cause damage to the water softener. Caution! Grains of salt and salty water on the bottom of the appliance can cause corrosion. Fill the appliance with salt before you start a washing programme to prevent corrosion. 4. Remove the salt around the opening of the salt container. 5. Turn the cap clockwise to close the salt container.
electrolux during the subsequent washing programme. 4. Close the rinse aid dispenser. Adjusting the rinse aid dosage The rinse aid is set at the factory at position 4. You can set the rinse aid dosage between position 1 (lowest dosage) and position 6 (highest dosage). 2. Fill the rinse aid dispenser with rinse aid. The mark 'max.' shows the maximum level. 1. Turn the rinse aid dial to increase or decrease the dosage. – Increase the dosage if there are water droplets or limescale on the dishes.
electrolux 9 • Put light items in the upper basket. Make sure that the items do not move. Caution! Make sure that the spray arms can move freely before you start a washing programme. Warning! Always close the door after you load or unload the appliance. An open door can be dangerous. Lower basket Put saucepans, lids, plates, salad bowls and cutlery in the lower basket. Arrange service dishes and large lids around the edge of the basket.
electrolux Use the cutlery grids. If the dimensions of the cutlery prevent use of the cutlery grids, you can easily hide them. The cutlery basket has two parts. You can use these parts separately for more loading flexibility. To disassemble the parts, move them horizontally in opposite directions and pull them apart. To assemble the parts, put them together and move horizontally to each other. Upper basket The upper basket is for saucers, salad bowls, cups, glasses, pots and lids.
electrolux 11 Maximum height of the dishes in the lower basket Lower position 27 cm Do these steps to move the upper basket to the upper position: 1. Pull the basket out until it stops. 2. Carefully lift the two sides until the mechanism is engaged and the basket is stable. You can easily lower the central rows of prongs for more loading flexibility. Do these steps to move the upper basket to the lower position: 1. Pull the basket out until it stops. 2. Carefully lift the two sides upwards. 3.
electrolux 4. If you use detergent tablets, put the detergent tablet in the detergent dispenser (A). 2. Fill the detergent dispenser (A) with detergent. The marking shows the dosage: 20 = approximately 20 g of detergent 30 = approximately 30 g of detergent. 3. If you use a washing programme with prewash phase, put more detergent in the prewash detergent compartment (B). A 5. Close the lid of the detergent dispenser. Press the lid until it locks into position.
electrolux 13 • Press and hold the two multitab buttons (function buttons D and E). The multitab indicator light comes on. To deactivate the multitab function: • Press and hold the two multitab buttons (function buttons D and E). The multitab indicator light goes off. Do these steps if the drying results are not satisfactory: 1. Fill the rinse aid dispenser with rinse aid. 2. Activate the rinse aid dispenser. 3. Set the rinse aid dosage to position 2.
electrolux Interrupting a washing programme Open the door. • The programme stops. Close the door. • The programme continues from the point of interruption. Cancelling a washing programme 1. Press and hold function buttons B and C until: – All the programme lights come on, – The programme-in-progress indicator light goes off. 2. Release function buttons B and C to cancel the washing programme. At this time you can do these steps: 1. Switch off the appliance. 2. Set a new washing programme .
electrolux 15 Programme Degree of soil Type of load Programme description Automatic1) Any Crockery, cutlery, pots Prewash and pans Main wash up to 45°C or 70°C 1 or 2 intermediate rinses Final rinse Drying Quick2) Normal or light soil Crockery and cutlery Main wash up to 60°C Final rinse Economy3) Normal soil Crockery and cutlery Prewash Main wash up to 50°C 1 intermediate rinse Final rinse Drying Prewash Any Partial load (to be completed later in the day).
electrolux The dishwasher has three filters: 1. coarse filter (A) 2. microfilter (B) 3. flat filter (C) A B C Do these steps to clean the filters: 1. Open the door. 2. Remove the lower basket. 3. To unlock the filter system, turn the handle on the microfilter (B) approximately 1/4 anticlockwise. 8. Clean the filters below running water. 9. Put the flat filter (C) in the bottom of the appliance. 10. Put the coarse filter (A) in the microfilter (B) and push the filters together. 11.
electrolux 17 Caution! Switch off the appliance before you do the below suggested corrective actions. Fault code and malfunction Possible cause and solution • digital display shows • The water tap is blocked or furred with limescale. Clean the water tap. The dishwasher does not fill with wa• The water tap is closed. ter Open the water tap. • The filter in the water inlet hose is blocked. Clean the filter. • The connection of the water inlet hose is not correct. The hose can be kinked or squashed.
electrolux The cleaning results are not satisfactory Dry water drop signs on glasses and dishes • Increase rinse aid dosage. • The detergent can be the cause. Technical data Dimensions Width cm 59,6 Height cm 81,8 - 89,8 Depth cm 57,5 Electrical connection - Voltage Overall power - Fuse Information on the electrical connection is given on the rating plate on the inner edge of the dishwasher door.
electrolux 19 water authority gives you the average mains pressure in your area. Make sure that there are no kinks in the water inlet hose and that the water inlet hose is not squashed or entangled. Fit the locknut correctly to prevent water leaks. Caution! Do not connect the appliance to new pipes or pipes that are not used for a long time. Let the water run for some minutes, then connect the inlet hose. The water inlet hose is double-walled and has an inner mains cable and a safety valve.
electrolux Caution! Make sure that the water couplings are tight to prevent water leakage. Electrical connection Warning! The manufacturer is not responsible if you do not follow these safety precautions. Ground the appliance according to safety precautions. Make sure that the rated voltage and type of power on the rating plate agree with the voltage and the power of the local power supply. Always use a correctly installed shockproof socket. Do not use multi-way plugs, connectors and extension cables.
electrolux 21
electrolux
electrolux 23
www.electrolux.com To buy accessories, consumables and spare parts at our online shop please visit: www.electrolux.co.
