ESF8570ROX EN Dishwasher User Manual
www.electrolux.com CONTENTS 1. SAFETY INFORMATION....................................................................................3 2. SAFETY INSTRUCTIONS..................................................................................4 3. PRODUCT DESCRIPTION................................................................................ 6 4. CONTROL PANEL............................................................................................. 7 5. PROGRAMMES.....................................
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference. 1.
www.electrolux.com • • • • • • • • • The operating water pressure (minimum and maximum) must be between 0.5 (0.05) / 8 (0.8) bar (MPa) Obey the maximum number of 15 place settings. If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard. Put the cutlery in the cutlery basket with the sharp ends pointing down or put them in the cutlery drawer in a horizontal position with the sharp edges down.
ENGLISH • • • • Connect the mains plug to the mains socket only at the end of the installation. Make sure that there is access to the mains plug after the installation. Do not pull the mains cable to disconnect the appliance. Always pull the mains plug. This appliance complies with the E.E.C. Directives. UK and Ireland only. This appliance is fitted with a 13 A mains plug. If it is necessary to change the mains plug fuse, use only a 13 A ASTA (BS 1362) fuse. 2.
www.electrolux.com 3.
ENGLISH 4. CONTROL PANEL 1 2 3 8 1 2 3 4 5 On/off button Program button Programme indicators Display Delay button 4 7 5 6 6 Start button 7 Indicators 8 Option button 4.1 Indicators Indicator Description Salt indicator. It is on when the salt container needs refilling. It is al‐ ways off while the programme operates. Rinse aid indicator. It is on when the rinse aid dispenser needs refill‐ ing. It is always off while the programme operates. Washing phase indicator.
www.electrolux.
ENGLISH Water (l) Energy (kWh) Duration (min) 14 - 16 1.2 - 1.5 160 - 180 12.5 - 14.5 1.4 - 1.7 170 - 190 10 0.9 30 4 0.1 14 Programme 1) 9 1) The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity of dishes can change the values. 5.2 Information for test institutes To receive the necessary information for conducting performance tests (e.g.
www.electrolux.com The water softener should be adjusted according to the hardness of the water in your area. Your local water authority can advise you on the hardness of the water in your area. It is important to set the right level of the water softener to assure good washing results. Water hardness German de‐ grees (°dH) French de‐ grees (°fH) mmol/l Clarke de‐ grees Water softener level 47 - 50 84 - 90 8.4 - 9.0 58 - 63 10 43 - 46 76 - 83 7.6 - 8.3 53 - 57 9 37 - 42 65 - 75 6.
ENGLISH 11 How to deactivate the rinse aid empty notification Make sure the appliance is in user mode. 1. Press Option. • The indicators are off. • The indicator still flashes. The display shows the current • , and = the rinse aid empty setting: notification is activated (factory setting). 2. Press Option to change the setting. During the drying phase, the door opens automatically and remains ajar. = the rinse aid empty notification is deactivated. 3. Press on/off to confirm the setting.
www.electrolux.com 6.6 MyFavourite This option allows to set and save the most frequently used programme. It is possible to save only 1 programme. A new setting cancels the previous one. How to save the MyFavourite programme 1. Set the chosen programme. It is also possible to set applicable options together with the programme. 2. Press and hold simultaneously Program and Delay until the indicators of the programme and the options flash for a few seconds.
ENGLISH How to activate TimeManager Press Option until the indicator 13 The display shows the updated programme duration. is on. 8. BEFORE FIRST USE 1. Make sure that the current level of the water softener agrees with the hardness of the water supply. If not, adjust the level of the water softener. 2. Fill the salt container. 3. Fill the rinse aid dispenser. 4. Open the water tap. 5. Start a programme to remove any processing residuals that can still be inside the appliance.
www.electrolux.com 8.2 How to fill the rinse aid dispenser A B CAUTION! Only use rinse aid designed specifically for dishwashers. 1. Open the lid (C). 2. Fill the dispenser (B) until the rinse aid reaches the marking ''MAX''. 3. Remove the spilled rinse aid with an absorbent cloth to prevent excessive foam formation. 4. Close the lid. Make sure that the lid locks into position. Fill the rinse aid dispenser when the indicator (A) is clear. C 9. DAILY USE 1. Open the water tap. 2.
ENGLISH • 15 If you want to select the MyFavourite programme, press and hold Program until the MyFavourite setting comes on. The display shows the programme duration. 4. Set the applicable options. 5. Press Start to start the programme. • The washing phase indicator comes on . • The programme duration starts to decrease with steps of 1 minute.
www.electrolux.com 10. HINTS AND TIPS 10.1 General Follow the hints below to ensure optimal cleaning and drying results in daily use and to help you protect the environment. • • • • • • Remove larger residues of food from the dishes into the waste bin. Do not pre-rinse dishes by hand. When needed, select a programme with a prewash phase. Always use the whole space of the baskets. Make sure that items in the baskets do not touch or cover each other.
ENGLISH 10.5 Before starting a programme • Before you start the selected programme, make sure that: 10.6 Unloading the baskets • • • • • • The filters are clean and correctly installed. The cap of the salt container is tight. The spray arms are not clogged. There is enough salt and rinse aid (unless you use multi-tablets). The arrangement of the items in the baskets is correct. The programme is suitable to the type of load and the degree of soil. 17 The correct quantity of detergent is used. 1.
www.electrolux.com 11.2 Cleaning the upper spray arm We recommend to clean the upper spray arm regularly to prevent soil from clogging the holes. Clogged holes can cause unsatisfactory washing results. 1. Pull out the upper basket. 2. To detach the spray arm from the basket, press the spray arm upwards and simultaneously turn it clockwise. 5. Make sure that there are no residues of food or soil in or around the edge of the sump. 6. Put back in place the flat filter (A).
ENGLISH • • 11.3 Internal cleaning • • Carefully clean the appliance, including the rubber gasket of the door, with a soft damp cloth. To maintain the performance of your appliance, use a cleaning product designed specifically for dishwashers 19 at least once a month. Carefully follow the instructions on the packaging of the product. Do not use abrasive products, abrasive cleaning pads, sharp tools, strong chemicals, scourer or solvents.
www.electrolux.com Problem and alarm code Possible cause and solution The appliance does not fill with water. • • The display shows or . • • • The appliance does not drain the water. The display shows . • • • • The anti-flood device is on. • The display shows . Make sure that the water tap is open. Make sure that the pressure of the water supply is not too low. For this information, contact your local water authority. Make sure that the water tap is not clogged.
ENGLISH Refer to "Before first use", "Daily use", or "Hints and tips" for other possible causes. Once you have checked the appliance, deactivate and activate the appliance. If 21 the problem occurs again, contact an Authorised Service Centre. For alarm codes not described in the table, contact an Authorised Service Centre. 12.1 The washing and drying results are not satisfactory Problem Possible cause and solution Poor washing results. • • • Poor drying results.
www.electrolux.com Problem Possible cause and solution Traces of rust on cutlery. • • There are residues of deter‐ gent in the dispenser at the end of the programme. • • • There is too much salt in the water used for wash‐ ing. Refer to "The water softener". Silver and stainless steel cutlery were placed to‐ gether. Avoid putting silver and stainless steel items close together. The detergent tablet got stuck in the dispenser and was not completely washed away by water.
ENGLISH Water supply Cold water or hot water 2) max 60 °C Capacity Place settings 15 Power consumption Left-on mode (W) 5.0 Power consumption Off-mode (W) 0.10 23 1) Refer to the rating plate for other values. 2) If the hot water comes from alternative source of energy, (e.g. solar panels, aeolian ener‐ gy), use the hot water supply to decrease energy consumption. 14.
Made in Italy 117874721-A-352018 www.electrolux.
