ESF5206LOW EN Dishwasher User Manual
www.electrolux.com CONTENTS 1. SAFETY INFORMATION....................................................................................3 2. SAFETY INSTRUCTIONS..................................................................................4 3. PRODUCT DESCRIPTION................................................................................ 6 4. CONTROL PANEL............................................................................................. 7 5. PROGRAMMES.....................................
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference. 1.
www.electrolux.com • • • • • • • • • The operating water pressure (minimum and maximum) must be between 0.5 (0.05) / 8 (0.8) bar (MPa) Obey the maximum number of 13 place settings. If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard. Put the cutlery in the cutlery basket with the sharp ends pointing down or put them in the cutlery drawer in a horizontal position with the sharp edges down.
ENGLISH • • • • Connect the mains plug to the mains socket only at the end of the installation. Make sure that there is access to the mains plug after the installation. Do not pull the mains cable to disconnect the appliance. Always pull the mains plug. This appliance complies with the E.E.C. Directives. UK and Ireland only. This appliance is fitted with a 13 A mains plug. If it is necessary to change the mains plug fuse, use only a 13 A ASTA (BS 1362) fuse. 2.
www.electrolux.com 3.
ENGLISH 4. CONTROL PANEL 1 2 6 1 2 3 4 On/off indicator Programme marker Indicators Delay button 3 5 4 5 Start button 6 Programme knob 4.1 Indicators Indicator Description Washing phase. It comes on when the washing phase operates. Drying phase. It comes on when the drying phase operates. End indicator. Rinse aid indicator. It is always off while the programme operates. Salt indicator. It is always off while the programme operates. 5.
www.electrolux.com Programme 2) 3) 4) Degree of soil Programme Type of load phases Consumption values 1) Duration (min) Energy (kWh) Water (l) 1.039 11 Normal soil Crockery and cutlery • • • • Prewash Wash 50 °C Rinses Dry 227 Heavy soil Crockery, cut‐ lery, pots and pans • • • • Prewash Wash 70 °C Rinses Dry 155 - 170 1.5 - 1.7 14 - 15 Normal soil Crockery and cutlery • • • • Prewash Wash 65 °C Rinses Dry 130 - 140 1.4 - 1.6 15 - 17 Fresh soil Crockery and cutlery • 30 0.
ENGLISH How to set the programme selection mode The appliance is in programme selection mode when the on/off indicator is on and Start indicator flashes. After activation, the appliance is in programme selection mode by default. If not, set the programme selection mode the following way: Press and hold simultaneously Start and Delay until the appliance is in programme selection mode. The higher the content of these minerals, the harder your water is. Water hardness is measured in equivalent scales.
www.electrolux.com 2. To enter the user mode, press and hold Delay. At the same time turn the knob counterclockwise until the programme marker indicates the first programme. Release the Delay when the indicators Start and on/off start flashing. The intermittent flashing of shows the current setting, e.g. 5 flashes + pause + 5 flashes = level 5. 3. Press Delay repeatedly to change the setting. Each pressing of Delay increases the level number.
ENGLISH hardness of the water supply. If not, adjust the level of the water softener. 2. Fill the salt container. 3. Fill the rinse aid dispenser. 4. Open the water tap. 5. Start a programme to remove any processing residuals that can still be inside the appliance. Do not use detergent and do not put dishes in the baskets. After starting the programme, the appliance recharges the resin in the water softener for up to 5 minutes. The washing phase starts only after this procedure is complete.
www.electrolux.com 1. Press the release button (D) to open the lid (C). 2. Pour the rinse aid in the dispenser (A) until the liquid reaches the fill level 'max'. 3. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam. 4. Close the lid. Make sure that the release button locks into position. You can turn the selector of the released quantity (B) between position 1 (lowest quantity) and position 4 or 6 (highest quantity). 8. DAILY USE 1. Open the water tap. 2.
ENGLISH 13 2. Press Delay to delay the start of the programme of 3 hours. The delay indicator comes on. 3. Press Start. Start indicator comes on. When the countdown is completed, the programme starts. Cancelling the delay start while the countdown operates Opening the door while the appliance operates Cancelling the programme Opening the door while a programme is running stops the appliance. It may affect the energy consumption and the programme duration.
www.electrolux.com • • • • In areas with hard and very hard water we recommend to use plain dishwasher detergent (powder, gel, tablets containing no additional agents), rinse aid and salt separately for optimal cleaning and drying results. At least once a month run the appliance with the use of appliance cleaner which is particularly suitable for this purpose. Detergent tablets do not fully dissolve with short programmes.
ENGLISH 15 10. CARE AND CLEANING WARNING! Before maintenance, deactivate the appliance and disconnect the mains plug from the main socket. Dirty filters and clogged spray arms decrease the washing results. Make a check regularly and, if necessary, clean them. 3. Remove the flat filter (A). 4. Wash the filters. 10.1 Cleaning the filters The filter system is made of 3 parts. C B A 5. Make sure that there are no residues of food or soil in or around the edge of the sump. 6.
www.electrolux.com 10.3 External cleaning • • • Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads or solvents. 10.4 Internal cleaning • • CAUTION! An incorrect position of the filters can cause bad washing results and damage to the appliance. • 10.2 Cleaning the spray arms Do not remove the spray arms. If the holes in the spray arms are clogged, remove remaining parts of soil with a thin pointed object.
ENGLISH Problem and alarm code Possible cause and solution The programme does not start. • • • • The appliance does not fill with wa‐ ter. • The end indicator flashes 1 time intermittently. • The Start indicator flashes con‐ tinuously. • • • • • 17 Make sure that the appliance door is closed. Press Start. If the delay start is set, cancel the setting or wait for the end of the countdown. The appliance has started the procedure to recharge the resin inside the water softener.
www.electrolux.com Problem and alarm code Possible cause and solution The appliance trips the circuit-beak‐ • er. • Refer to "Before first use", "Daily use", or "Hints and tips" for other possible causes. The amperage is insufficient to supply si‐ multaneously all the appliances in use. Check the socket amperage and the capaci‐ ty of the meter or turn off one of the applian‐ ces in use. Internal electrical fault of the appliance. Contact an Authorised Service Centre.
ENGLISH Problem Possible cause and solution The dishes are wet. • • • • • 19 For the best drying performance activate AirDry. The programme does not have a drying phase or has a drying phase with low temperature. The rinse aid dispenser is empty. The quality of the rinse aid can be the cause. The quality of the multi-tablets can be the cause. Try a different brand or activate the rinse aid dis‐ penser and use rinse aid and multi-tablets together. The interior of the appliance is wet.
www.electrolux.com Refer to "Before first use", "Daily use" or "Hints and tips" for other possible causes. 12. PRODUCT INFORMATION SHEET Trade Mark Electrolux Model ESF5206LOW Rated capacity (standard place settings) 13 Energy efficiency class A+ Energy consumption in kWh per year, based on 280 standard cleaning cycles using cold water fill and the consumption of the low power modes. The actual energy consumption will depend on how the appliance is used.
ENGLISH Water supply Cold water or hot water 2) 21 max 60 °C 1) Refer to the rating plate for other values. 2) If the hot water comes from alternative source of energy (e.g. solar panels), use the hot water supply to decrease energy consumption. 14. ENVIRONMENTAL CONCERNS Recycle materials with the symbol . Put the packaging in relevant containers to recycle it. Help protect the environment and human health by recycling waste of electrical and electronic appliances.
www.electrolux.
ENGLISH 23
156932250-A-442018 www.electrolux.
