ESF5201LOW EN DISHWASHER USER MANUAL
www.electrolux.com CONTENTS 1. SAFETY INFORMATION...................................................................................... 2 2. SAFETY INSTRUCTIONS.....................................................................................4 3. PRODUCT DESCRIPTION................................................................................... 5 4. CONTROL PANEL............................................................................................... 6 5. PROGRAMMES..........................
ENGLISH 3 responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.
www.electrolux.com • • • • Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket. Do not use water spray and steam to clean the appliance. The ventilation openings in the base (if applicable) must not be obstructed by a carpet. The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. 2. SAFETY INSTRUCTIONS 2.1 Installation • Remove all the packaging. • Do not install or use a damaged appliance.
ENGLISH from the mains socket. Contact the Authorised Service Centre to replace the water inlet hose. 2.4 Use • Do not sit or stand on the open door. • Dishwasher detergents are dangerous. Obey the safety instructions on the detergent packaging. • Do not drink and play with the water in the appliance. • Do not remove the dishes from the appliance until the programme is completed. There can be detergent on the dishes. • The appliance can release hot steam if you open the door while a programme operates.
www.electrolux.com 7 8 9 10 Air vent Rinse aid dispenser Detergent dispenser Cutlery basket 11 Lower basket 12 Upper basket 4. CONTROL PANEL 1 2 6 1 2 3 4 On/off indicator Programme marker Indicators Delay button 3 5 4 5 Start button 6 Programme knob 4.1 Indicators Indicator Description Washing phase. It comes on when the washing phase operates. Drying phase. It comes on when the drying phase operates. End indicator. Salt indicator. It is always off while the programme operates.
ENGLISH 7 5. PROGRAMMES Programme 2) 3) 4) 5) Degree of soil Programme Type of load phases Consumption values 1) Duration (min) Energy (kWh) Water (l) 1.039 11 Normal soil Crockery and cutlery • • • • Prewash Wash 50 °C Rinses Dry 195 Heavy soil Crockery, cutlery, pots and pans • • • • Prewash Wash 70 °C Rinses Dry 150 - 170 1.5 - 1.6 13 - 15 Normal soil Crockery and cutlery • • • • Prewash Wash 65 °C Rinses Dry 120 - 130 1.3 - 1.
www.electrolux.com detrimental effect on the washing results and on the appliance. How to set the programme selection mode The higher the content of these minerals, the harder your water is. Water hardness is measured in equivalent scales. The appliance is in programme selection mode when the on/off indicator comes on and start indicator starts to flash. When you activate the appliance, usually it is in programme selection mode.
ENGLISH 2. To enter the user mode, press and hold Delay. At the same time turn the knob counterclockwise until the programme marker is aligned with the first programme. Release Delay when the indicators Start and on/off start to flash. 3. Press Delay. starts to flash. • The indicator • The indicators Start and on/off continues to flash. • The intermittent flashing of refers to the current set level, e.g. 5 flashes + pause + 5 flashes = level 5. 4. Press Delay again and again to change the setting.
www.electrolux.com 7.2 How to fill the rinse aid dispenser A D CAUTION! Only use rinse aid specifically designed for dishwashers. B C You can turn the selector of the released quantity (B) between position 1 (lowest quantity) and position 4 or 6 (highest quantity). B A 1. Press the release button (D) to open the lid (C). 2. Pour the rinse aid in the dispenser (A) until the liquid reaches the fill level 'max'. 3. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam. 4.
ENGLISH A 30 B 11 Starting a programme with delay start D 20 C 1. Press the release button (B) to open the lid (C). 2. Put the detergent, in powder or tablets, in the compartment (A). 3. If the programme has a prewash phase, put a small quantity of detergent in the compartment (D). 4. Close the lid. Make sure that the release button locks into position. 8.2 Using the multi-tablets When you use tablets, that contain salt and rinse aid, do not fill the salt container and the rinse aid dispenser. 1.
www.electrolux.com 9. HINTS AND TIPS 9.1 General The following hints will ensure optimal cleaning and drying results in daily use and also help to protect the environment. • Remove larger residues of food from the dishes into the waste bin. • Do not pre-rinse dishes by hand. When needed, use the prewash programme (if available) or select a programme with a prewash phase. • Always use the whole space of the baskets.
ENGLISH 13 9.5 Before starting a programme 9.6 Unloading the baskets Make sure that: 1. Let the tableware cool down before you remove it from the appliance. Hot items can be easily damaged. 2. First remove items from the lower basket, then from the upper basket. • The filters are clean and correctly installed. • The cap of the salt container is tight. • The spray arms are not clogged. • There is dishwasher salt and rinse aid (unless you use multi- tablets).
www.electrolux.com CAUTION! An incorrect position of the filters can cause bad washing results and damage to the appliance. 10.2 Cleaning the spray arms Do not remove the spray arms. If the holes in the spray arms are clogged, remove remaining parts of soil with a thin pointed object. 10.3 External cleaning 5. Make sure that there are no residues of food or soil in or around the edge of the sump. 6. Put back in place the flat filter (A). Make sure that it is correctly positioned under the 2 guides.
ENGLISH Authorised Service Centre, check if you can solve the problem by yourself with the help of the information in the table. WARNING! Repairs not properly done may result in serious risk to the safety of the user. Any repairs must be performed by qualified personnel. 15 With some problems the end indicator flashes intermittently indicating a malfunction. The majority of problems that can occur can be solved without the need to contact an Authorised Service Centre.
www.electrolux.com Problem and alarm code Possible cause and solution The program lasts too long. • If the delayed start option is set, cancel the delay setting or wait for the end of the countdown. Small leak from the appliance door. • The appliance is not level. Loosen or tighten the adjustable feet (if applicable). • The appliance door is not centred on the tub. Adjust the rear foot (if applicable). The appliance door is difficult to close. • The appliance is not level.
ENGLISH 17 Problem Possible cause and solution There are whitish streaks or bluish layers on glasses and dishes. • The release quantity of rinse aid is too much. Adjust the rinse aid level to a lower level. • The quantity of detergent is too much. There are stains and dry water drops on glasses and dishes. • The released quantity of rinse aid is not sufficient. Adjust the rinse aid level to a higher level. • The quality of the rinse aid can be the cause. The dishes are wet.
www.electrolux.com 12. TECHNICAL INFORMATION Dimensions Width / height / depth (mm) 600 / 850 / 625 Electrical connection 1) Voltage (V) 220 - 240 Frequency (Hz) 50 Water supply pressure Min. / max. bar (MPa) 0.5 (0.05) / 8 (0.8) Water supply Cold water or hot water 2) max 60 °C Capacity Place settings 13 Power consumption Left-on mode (W) 0.50 Power consumption Off-mode (W) 0.50 1) Refer to the rating plate for other values.
ENGLISH 19
100003061-A-182015 www.electrolux.
