D i s h w a s h e r Model ESF 4130 GB Instruction book
Contents For the user For the installer Important safety information 3 Description of the appliance 4 The control panel 5 Before use Setting the water softener Rinse aid 6 6 9 Using your appliance Loading your appliance Adjusting the height of the upper basket Use of detergent 10 10 11 12 Hints and tips 13 Washing programmes 14 Operating sequence 15 Maintenance and cleaning 17 Something not working Protection against flooding Security system Technical specifications 19 20 20 20 Install
Important safety information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. This information has been provided in the interest of your safety.
Description of the appliance IN111 1. Upper basket stop 8. Lower spray arm 2. Upper spray arm 9. Upper basket 3. Salt container 10. Worktop 4. Detergent dispenser 5. Control panel 6. Rinse aid dispenser 7.
The control panel 1. Programme selection push buttons Salt and rinse aid indicator lights SALT refilling indicator light illuminates when the salt has run out and the salt container requires refilling. 2. HALF LOAD push button RINSE AID refilling indicator light illuminates when the rinse aid has run out and the rinse aid container requires refilling. This option is useful and economical when only a few dishes need washing.
Before use Before using your dishwasher for the first time: 1. Ensure that the electrical and water connections comply with the installation instructions 2. Remove all packaging from inside the appliance 3. Set the water softener 4. Pour 1 litre of water inside the salt container and then fill with salt 5. Fill the rinse aid dispenser.
The current level is indicated by the number of flashes made by the 70° 80’ indicator light, that alternates 5 seconds off with a number of flashes, this for about 60 seconds. Example: 1 flash = 2 flashes = 3 flashes = 4 flashes = 5 flashes = level 1 level 2 level 3 level 4 level 5 3. To change the level, press the 70° 80’ programme push button. Each time the push button is pressed the level changes.
Filling with salt Only use salt specifically designed for use in dishwashers. All other types of salt not specifically designed for use in a dishwasher, especially table salt, will damage the water softener. Only fill with salt just before starting one of the complete washing programmes. This will prevent any grains of salt or salty water, which may have been spilled, remaining on the bottom of the machine for any period of time, which may cause corrosion. To fill: 1.
Rinse aid Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying. The dispenser, which is positioned inside the door, holds about 110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing programmes, depending upon the dosage setting. Filling with rinse aid 1. Open the container by turning the lid (A) anticlockwise. A BR01 2. Add the rinse aid until the container is completely full. The indicator (B) will be completely dark. 3.
Using your appliance Loading your appliance Before placing dishes in the machine, remove any scraps of food, to avoid clogging the filters and consequently reducing the performance. Do not load very small items which can fall through the baskets. Open the door and slide out the baskets to load the dishes. UI51 The lower basket The lower basket is designed to take saucepans, lids, plates, salad bowls, cutlery etc.
The upper basket The upper basket is designed for plates (dessert plates, saucers, dinner plates of up to 24 cm in diameter), salad bowls, cups and glasses. Arrange items on and underneath the cup racks so that water can reach all surfaces. Glasses with long stems can be placed upside down in the cup racks. The cup rack on the left folds upwards to increase your loading felxibility. US69 Light items (plastic bowls etc.) should be loaded in the upper basket and arranged so they do not move.
Use of detergent Only use detergents specifically designed for use in dishwashers. If using powder detergents proceed as follows: 1. Open the dispenser lid by pulling the catch (D). 2. Add the detergent according to the instructions given in the Washing programmes chart. As all detergents are not the same, you should also consult the instructions on the packet. 3. Always close the lid. 4. If the programme has a prewash add the required detergent over the lid of the dispenser.
Hints and tips To save energy Items not suitable for dishwashers Place dishes in the machine immediately after every meal and wait until the dishwasher is full before washing. Do not prewash dishes under running water.
Washing programmes Programme Degree of soil and type of load Required push buttons Recommended quantity of detergent wash * 70° 80’ 65° ** 60° *** 50° Heavy soil. Crockery, cutlery, pots and pans ON-OFF + 70° 80’ Normal soil. Crockery and cutlery ON-OFF + 65° Fresh soil. Crockery and cutlery Normal soil.
Operating sequence 1. Check the filters 8a. Setting and starting the programme without DELAY START Ensure they are clean and properly positioned (see "Maintenance and cleaning"). Press the push button corresponding to the wanted programme: the indicator light corresponding to the programme illuminates and the phase indicator lights foreseen for that programme start flashing. 2. Press the ON-OFF push button The ON-OFF indicator light will come on. Select, if required, the HALF LOAD option.
During the countdown the only indicator lights illuminate are the programme light and the light of the number of hours to the start of the programme. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. Once the delayed time has elapsed the programme will start automatically.
Maintenance and cleaning Internal cleaning Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth. We recommend every 3 months or run a 65°C wash without dishes using detergent. Cleaning the filters The filters in the base of the washing compartment are to large extent self-cleaning. Nevertheless the filters should be checked and cleaned from time to time. Dirty filters will degrade the washing result. 1. Open the door, remove the lower basket.
External cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc....). Prolonged periods of nonoperation If you are not using the machine for any period of time you are advised to: 1. Unplug the appliance and then turn off the water. 2. Fill the rinse aid dispenser. 3. Leave the door ajar to prevent the formation of any unpleasant smells. 4.
Something not working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. The dishwasher is fitted with a number of alarm systems which can help you to quickly determine the cause of any problems. The dishwasher will not start or stops during operation. All push buttons are inoperative except for the ON-OFF push button.
If after all these checks, the problem persists, contact your local Service Force Centre, quoting the model and serial number. This information can be found on the rating plate located on the right hand side of the dishwasher door (see picture). Protection against flooding Prod.No. ........ Ser. No. ......... Mod. ........ RA01 The machine is fitted with a device in the bottom of the machine to protect against flooding.
Installation instructions Remove all packaging before positioning the machine. If possible, position the machine next to a water tap and a drain. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person. Water supply connections This dishwasher may be fed with either hot (max. 60°) or cold water.
Water outlet hose connection 1 2 3 Ø Ø 18 21 1. To the sink outlet siphon, securing it if necessary with a clip. min 4 cm The end of the drain hose can be connected in the following ways: 3. To a stand pipe provided with vent-hole, minimum internal diameter 4 cm. min 30 cm max 100 cm max 100 cm 2. Hooked over the edge of the sink using the special curved plastic guide provided.
Fitting under a counter (kitchen worktop or sink) By removing the machine’s worktop, you can install it under a close fitting sink unit or a pre-existing top, providing the dimensions of the recess correspond to those shown in the picture. Proceed as follows: - Remove the machine’s worktop by unscrewing the two front retaining screws, pull from the front and slide out the rear slots, lifting the worktop. IN02 Insert the machine after adjusting height and levelling with the adjustable feet.
The Electrolux Group. The world’s No.1 choice. The Electrolux Group is the world’s largest producer of powered appliances for kitchen, cleaning and outdoor use. More than 55 million Electrolux Group products (such as refrigerators, cookers, vacuum cleaners, chain saws and lawn mowers) are sold each year to a value of approx. 14 billion USD in more than 150 countries around the world.
