user manual Fridge ERN34800
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.
electrolux 3 damage to the cord may cause a shortcircuit, fire and/or electric shock. Warning! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel. • • • • 1. Power cord must not be lengthened. 2. Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or damaged power plug may overheat and cause a fire. 3. Make sure that you can come to the mains plug of the appliance. 4.
electrolux in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. The materials used on this appliance marked by the symbol are recyclable.
electrolux 5 When the appliance is switched off, Display also goes off. Temperature regulation The temperature within the appliance is controlled by the Temperature regulator situated at the top of the cabinet. To operate the appliance, proceed as follows: • turn the knob clockwise to obtain the maximum coldness • turn the knob counter- clockwise to obtain the minimum coldness. The intermediate position is usually the most suitable.
electrolux Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be placed at different heights. To make these adjustments proceed as follows: gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. This bottle holder shelf can be tilted in order to store previously opened bottles. To obtain this result, pull the shelf up so it can rotate upwards and be placed on the next higher level.
electrolux 7 This device allows for rapid cooling of foods and a more uniform temperature in the compartment. Important! Switch on the fan when the ambient temperature exceeds 25°C. 2 1 HELPFUL HINTS AND TIPS Hints for energy saving • Do not open the door frequently or leave it open longer than absolutely necessary.
electrolux charging must therefore only be carried out by authorized technicians. Periodic cleaning The equipment has to be cleaned regularly: • clean the inside and accessories with lukewarm water and some neutral soap. • regularly check the door seals and wipe clean to ensure they are clean and free from debris. • rinse and dry thoroughly. er at the back of the appliance, over the motor compressor, where it evaporates.
electrolux 9 Problem Possible cause Solution The appliance is switched off. Switch on the appliance. The mains plug is not connected to the mains socket correctly. Connect the mains plug to the mains socket correctly. The appliance has no power. There is no voltage in the mains socket. Connect a different electrical appliance to the mains socket. Contact a qualified electrician. The lamp is in stand-by. Close and open the door. The lamp is defective. Refer to "Replacing the lamp".
electrolux household appliances. the maximum power is shown on the light bulb cover) 4. Replace the light cover by sliding it into its original position. 5. Reconnect the appliance. 6. Open the door and check if the light comes on. Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "Installation". 3. If necessary, replace the defective door gaskets. Contact the Service Center.
electrolux 11 Warning! This appliance must be earthed. The manufacturer declines any liability should these safety measures not be observed. 1 2 5. Make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. 6. Switch on the appliance. The appliance is supplied with a 13 amp plug fitted 2 . In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used.
electrolux min. 200 cm2 min. 200 cm2 On the opposite side: 1. Tighten the lower pin. 2. Install the spacer. 3. Install the door. 4. Tighten the upper pin. Installing the appliance Caution! Make sure that the mains cable can move freely. Do the following steps: 1. Drill the unit using a Ø 2.5 mm drill (10 mm max. penetration). Fix the square fitting to the appliance. 13mm 2,5 Ventilation requirements The airflow behind the appliance must be sufficient. 2. Install the appliance in the niche.
electrolux 13 the appliance and the cupboard frontedge is 44 mm. Push the appliance in the direction of the arrows (2) against the cupboard on the opposite side of the hinge. Make sure that the clearance between the appliance and the cupboard is 4 mm. I 2 5. Push the sealing strip between the appliance and the adjacent cabinet. 1 3. Adjust the appliance in the niche. The lower hinge cover (in the accessories bag) makes sure that the distance between the appliance and the kitchen furniture is correct.
electrolux Install the vent grille (B). Attach the hinge covers (E) to the hinge. 10. Push the part (Hc) on the part (Ha). Ha D C E E Hc B 8. Disconnect the parts (Ha), (Hb), (Hc) and (Hd). Ha Hb Hc 11. Open the appliance door and the kitchen furniture door at an angle of 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes. Remove the small squares and drill holes with ø 2 mm at 8 mm from the outer edge of the door.
electrolux 15 Hb Hb 13. Press the part (Hd) on the part (Hb). Hd Do a final check to make sure that: • All screws are tightened. • The sealing strip is attached tightly to the cabinet. • The door opens and closes correctly. ENVIRONMENTAL CONCERNS The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment.
www.electrolux.
