user manual Fridge ERN34800
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com CONTENTS 2 4 5 5 6 Care and Cleaning 6 What to do if… 7 Technical data 9 Installation 9 Environmental concerns 13 Subject to change without notice In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings.
electrolux 3 Warning! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel. • • • • 1. Power cord must not be lengthened. 2. Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or damaged power plug may overheat and cause a fire. 3. Make sure that you can come to the mains plug of the appliance. 4. Do not pull the mains cable. 5.
electrolux either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. The materials used on this appliance marked by the symbol are recyclable.
electrolux 5 When the appliance is switched off, Display also goes off. Temperature regulation The temperature within the appliance is controlled by the Temperature regulator situated at the top of the cabinet. To operate the appliance, proceed as follows: • turn the knob clockwise to obtain the maximum coldness • turn the knob counter- clockwise to obtain the minimum coldness. The intermediate position is usually the most suitable.
electrolux To make these adjustments proceed as follows: gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be placed at different heights. HELPFUL HINTS AND TIPS Hints for energy saving • Do not open the door frequently or leave it open longer than absolutely necessary.
electrolux 7 Periodic cleaning The equipment has to be cleaned regularly: • clean the inside and accessories with lukewarm water and some neutral soap. • regularly check the door seals and wipe clean to ensure they are clean and free from debris. • rinse and dry thoroughly. It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside.
electrolux Problem Possible cause Solution The appliance is switched off. Switch on the appliance. The mains plug is not connected to the mains socket correctly. Connect the mains plug to the mains socket correctly. The appliance has no power. There is no voltage in the mains socket. Connect a different electrical appliance to the mains socket. Contact a qualified electrician. The lamp is in stand-by. Close and open the door. The lamp is defective. Refer to "Replacing the lamp".
electrolux 9 4. Replace the light cover by sliding it into its original position. 5. Reconnect the appliance. 6. Open the door and check if the light comes on. Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "Installation". 3. If necessary, replace the defective door gaskets. Contact the Service Center.
electrolux current regulations, consulting a qualified electrician. The manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with the E.E.C. Directives. Removing the shelf holders Your appliance is equipped with shelf retainers that make it possible to secure the shelves during transportation. To remove them proceed as follows: 1. Move the shelf holders in the direction of the arrow (A). 2.
electrolux 11 pliance and the cupboard front-edge is 44 mm. Push the appliance in the direction of the arrows (2) against the cupboard on the opposite side of the hinge. Make sure that the clearance between the appliance and the cupboard is 4 mm. min. 200 cm2 min. 200 cm2 2 Installing the appliance 1 Caution! Make sure that the mains cable can move freely. Do the following steps: 1. Drill the unit using a Ø 2.5 mm drill (10 mm max. penetration). Fix the square fitting to the appliance. 13mm 2,5 3.
electrolux Attach the hinge covers (E) to the hinge. I D C E 5. Push the sealing strip between the appliance and the adjacent cabinet. E B 8. Disconnect the parts (Ha), (Hb), (Hc) and (Hd). Ha Hb Hc Hd 6. Remove the correct part from the hinge cover (E). Make sure to remove the part DX, in the case of right hinge, SX in opposite case. 9. Install the part (Ha) on the inner side of the kitchen furniture. ca. 50 mm 21 m m 7. Attach the covers (C, D) to the lugs and the hinge holes.
electrolux 13 12. Align the kitchen furniture door and the appliance door by adjusting the part Hb. Ha Hc 11. Open the appliance door and the kitchen furniture door at an angle of 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes. Remove the small squares and drill holes with ø 2 mm at 8 mm from the outer edge of the door. Place the small square on the guide again and fix it with the screws supplied. Hb 13.
electrolux
electrolux 15
www.electrolux.
