User manual

18
CONTENTS
Warnings 17
Use 19
Cleaning the interior 19
Use of the freezer - Starting 19
Temperature regulation 19
Quick-freezing 19
The temperature alarm light 20
Freezing fresh food 20
Storage of frozen food 20
Thawing 20
Ice-cube production 20
Use of the refrigerator - Operation 21
Temperature regulation 21
Fresh food refrigeration 21
Air circulation 21
Movable shelves 21
Positioning the door shelves 21
Hints 22
hints for refrigeration 22
Hints for freezing 22
Hints for storage of frozen food 22
Maintenance 23
Periodic cleaning 23
Periods of no operation 23
Interior light 23
Defrosting 23
Customer service and spare parts 24
Technical info 25
Installation 25
Location 25
Shelf holders 25
Electrical connection 26
Changing the opening direction of the doors 26
Instructions for totally built-in 27
speed up the thawing process other than those
recommended by the manufacturer. Never use
metal objects for cleaning your appliance as it
may get damaged.
Installation
• During normal operation, the condenser and
compressor at the back of the appliance heat up
considerably. For safety reasons, minimum
ventilation must be as shown in the instructions.
Attention: keep ventilation openings clear of
obstruction.
• Care must be taken to ensure that the appliance
does not stand on the electrical supply cable.
Important: if the supply cord is damaged, it must
be replaced by a special cord or assembly availa-
ble from the manufacturer or its service agent.
• If the appliance is transported horizontally, it is
possible that the oil contained in the compressor
flows in the refrigerant circuit. It is advisable to
wait at least two hours before connecting the
appliance to allow the oil to flow back in the
compressor.
• There are working parts in this product which
heat up. Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible food loss. See
installation instructions.
• Parts which heat up should not be exposed.
Wherever possible the back of the product should
be against a wall.
Environment Protection
This appliance does not contain gasses which
could damage the ozone layer, in either its
refrigerant circuit or insulation materials.The
appliance shall not be discarded together with
the urban refuse and rubbish. Avoid damaging
the cooling unit, especially at the rear near the
heat exchanger. Information on your local
disposal sites may be obtained from municipal
authorities.The materials used on this appliance
marked by the symbol are recyclable.
27
Instructions for totally built-in
appliances
Dimensions of the recess
Height (1) 1780 mm
Depth (2) 550 mm
Width (3) 560 mm
For safety reasons, minimum ventilation must be as
shown in Fig. Attention: keep ventilation openings
clear of obstruction.
50 mm
min.
200 cm
2
200 cm
2
min.
D567
PR01
540
50
3
2
1
Furthermore, it is necessary that the niche is provid
with a conduct of ventilation having the following
dimensions:
depth 50 mm
width 540 mm
Fit the appliance in the niche by making sure that it
stands against the interior surface of the unit on the
side where the door hinges of the appliances are
fitted. Insert the appliance until the upper strip butts
up against the unit (1) and make sure that the lower
hinge is in line with the surface of the unit (2).
D023
1
2
I
P
Fasten the appliance with 4 screws provided in the
kit included with the appliance.
(I = short) (P = long)