k ü h l s c h r a n k / r e f r i g e r a t o r / k y l s k å p / j ä ä k a a p p i / хoлoдильник GEBRAUCHSANWEISUNGEN INSTRUCTION BOOKLET BRUKSANVISNING KÄYTTÖOHJE РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ D ERN 1672 GB S FIN 2222 751-84 RUS
t Safety Instructions Please read these operating instructions carefully before installing the appliance. These warnings are provided in the interests of your safety. Ensure you fully understand them before installing or using the appliance. If you are unsure about the meaning of these warnings contact the Customer Care Department. Domestic Use ¥ The domestic refrigerators and freezers are designed to be used specifically for the storage of edible foodstuffs only.
Use and Control Before Use Wait two hours before connecting the appliance to allow the oil to flow back in the compressor. ¥ Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Internal Parts Storage shelves ¥ The shelves can be removed for cleaning.
Hints Hints for refrigeration Saving Energy ¥ Pay careful attention to where the cabinet is placed. See the section ÒInstallationÓ. When installed correctly the cabinet will consume less energy. ¥ Try to avoid keeping the doors open for long periods or opening the doors too frequently as warm air will enter the cabinet and cause the compressor to switch on unnecessarily often.
When the appliance is not in use Changing the light bulb Disconnect the appliance from the electricity supply. Empty all foods and clean the appliance, leaving the doors ajar to prevent unpleasant smells. ¥ Should the interior light fail to work, first switch off the appliance and disconnect from the electricity supply, then replace the bulb as follows: 1. unscrew the light cover securing screws. 2. unhook the moving part by pressing it as shown in the figure. 3.
Customer service and spare parts If you cannot find the remedy for a malfunction in these operating instructions, please contact your dealer or our customer service department and consult the Guarantee card. Selective ordering of replacement parts can save unnecessary travel and costs. For this reason always provide the following appliance information: ¥ Model Name ¥ Model Number (PNC) ¥ Serial Number (S-No.) This information can be found on the rating plate inside the cabenit on the left hand wall.
The climate classification can be found on the rating plate, which is located inside the cabinet on the left hand wall.
Building-in Dimensions of the recess Height of housing Depth of housing Width of housing 3. Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position. mm 880 mm 550 mm 560 50 540 0 56 55 0 880 D PR 32 C D727 1. Slide the appliance into the recess, pushing it against the wall on the handle side. 4.
6. Place guide (A) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. After having drilled holes, fix the guide with the screws supplied. 9. Should the lining up of the furniture door be necessary, use the clearance of slots. At the end of operations, it is necessary to check if the door of the furniture closes properly. 50mm A 20m m PR168 PR166 10. Fix cover (D) on guide (B) until it clips into place. 7.
Electrolux HemProdukter AB 923 631 693 S-105 45 Stockholm www.electrolux.
