kühlschrank / refrigerator GEBRAUCHSANWEISUNGEN INSTRUCTION BOOKLET ERN 1672 D 2222 751-83 GB
t Safety Instructions Please read these operating instructions carefully before installing the appliance. These warnings are provided in the interests of your safety. Ensure you fully understand them before installing or using the appliance. If you are unsure about the meaning of these warnings contact the Customer Care Department. ¥ Ice lollies can cause Ôfrost/freezer burnsÕ if consumed straight from the freezer. ¥ It is dangerous to try and alter the specifications or modify this product in any way.
Use and Control Before Use Internal Parts Storage shelves Wait two hours before connecting the appliance to allow the oil to flow back in the compressor. ¥ The shelves can be removed for cleaning. ¥ To permit storage of food packages of various sizes, the shelves can be placed at different heights. ¥ To remove the internal shelf pull forward until it can be tipped up or down and removed.
Hints Hints for refrigeration ¥ Do not store warm food or evaporating liquids in the refrigerator and do cover or wrap up the food, particularly if it has a strong smell. To help you use your refrigerator correctly, here are some useful hints: ¥ Raw meat (beef, pork, lamb & poultry): wrap in polythene bags and place on top of the salad compartment, this being the coldest spot in the refrigerator. Meat can only be stored safely in this way for one or two days at the most.
When the appliance is not in use Changing the light bulb Disconnect the appliance from the electricity supply. Empty all foods and clean the appliance, leaving the doors ajar to prevent unpleasant smells. ¥ Should the interior light fail to work, first switch off the appliance and disconnect from the electricity supply, then replace the bulb as follows: 1. unscrew the light cover securing screws. 2. unhook the moving part by pressing it as shown in the figure. 3.
Customer service and spare parts If you cannot find the remedy for a malfunction in these operating instructions, please contact your dealer or our customer service department and consult the Guarantee card. Selective ordering of replacement parts can save unnecessary travel and costs. For this reason always provide the following appliance information: ¥ Model Name ¥ Model Number (PNC) ¥ Serial Number (S-No.) This information can be found on the rating plate inside the cabenit on the left hand wall.
The climate classification can be found on the rating plate, which is located inside the cabinet on the left hand wall. The following table shows which ambient temperature is correct for each climate classification: Climate classification Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage.
Building-in Dimensions of the recess Height of housing Depth of housing Width of housing 3. Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position. mm 880 mm 550 mm 560 50 540 0 56 55 0 880 D PR 32 C D727 4. Apply covers (B) on joint cover lugs and into hinge holes. 1.
6. Place guide (A) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. After having drilled holes, fix the guide with the screws supplied. 9. Should the lining up of the furniture door be necessary, use the clearance of slots. At the end of operations, it is necessary to check if the door of the furniture closes properly. 50mm A 20m m PR168 PR166 10. Fix cover (D) on guide (B) until it clips into place. 7.
923 631 693 ELECTROLUX HOME PRODUCTS OPERATIONS EUROPE
