user manual Refrigerator ERN16510
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com CONTENTS Safety information Operation First use Daily use Helpful hints and tips 2 4 4 4 5 Care and cleaning 6 What to do if… 7 Technical data 8 Installation 8 Environmental concerns 13 Subject to change without notice In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings.
electrolux 3 damage to the cord may cause a shortcircuit, fire and/or electric shock. Warning! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel to avoid hazard. • • • • 1. Power cord must not be lengthened. 2. Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or damaged power plug may overheat and cause a fire. 3.
electrolux Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appli- ance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger.
electrolux 5 gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be placed at different heights. To make these adjustments proceed as follows: HELPFUL HINTS AND TIPS Normal Operating Sounds • You may hear a faint gurgling and a bubbling sound when the refrigerant is pumped through the coils or tubing. This is correct.
electrolux Butter and cheese: these should be placed in special airtight containers or wrapped in aluminium foil or polythene bags to exclude as much air as possible. Milk bottles: these should have a cap and should be stored in the bottle rack on the door. Bananas, potatoes, onions and garlic, if not packed, must not be kept in the refrigerator. CARE AND CLEANING Caution! Unplug the appliance before carrying out any maintenance operation.
electrolux 7 • leave the door/doors ajar to prevent unpleasant smells. If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure. WHAT TO DO IF… Warning! Before troubleshooting, disconnect the mains plug from the mains socket. Only a qualified electrician or competent person must do the troubleshooting that is not in this manual. Problem The appliance does not operate. The lamp does not operate.
electrolux Problem Possible cause Solution The product temperature is too high. Let the product temperature decrease to room temperature before storage. Many products are stored at the same time. Store less products at the same time. There is no cold air circulation in the appliance. Make sure that there is cold air circulation in the appliance. Replacing the lamp 1. Disconnect the mains plug from the mains socket. 2. Remove the screw from the lamp cover. 3.
electrolux 9 Positioning Install this appliance at a location where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance: Climate class Ambient temperature SN +10°C to + 32°C N +16°C to + 32°C ST +16°C to + 38°C T +16°C to + 43°C Electrical Connection Caution! Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Warning! This appliance must be earthed.
electrolux min. 200 cm2 min. 200 cm2 On the opposite side: 1. Tighten the lower pin. 2. Install the spacer. 3. Install the door. 4. Tighten the upper pin. Ventilation requirements The airflow behind the appliance must be sufficient. Installing the appliance Caution! Make sure that the mains cable can move freely. Do the following steps: 1. Apply the adhesive sealing strip to the appliance as shown in figure.
electrolux 11 2. Install the appliance in the niche. Push the appliance in the direction of the arrows (1) until the upper gap cover stops against the kitchen furniture. Push the appliance in the direction of the arrows (2) against the cupboard on the opposite side of the hinge. 4. Attach the appliance to the niche with 4 screws. I 2 1 3. Adjust the appliance in the niche. Make sure that the distance between the appliance and the cupboard frontedge is 44 mm.
electrolux 6. Attach the covers (C, D) to the lugs and the hinge holes. Attach the hinge covers (E) to the hinge. 9. Push the part (Hc) on the part (Ha). Ha D C Hc E E 7. Disconnect the parts (Ha), (Hb), (Hc) and (Hd). Ha Hb 10. Open the appliance door and the kitchen furniture door at an angle of 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes. 8 mm Hc Ha Hd 8.
electrolux 13 11. Remove the brackets and mark a distance of 8 mm from the outer edge of the door where the nail must be fitted (K). 13. Press the part (Hd) on the part (Hb). 8 mm Hb Hd K Ha 12. Place the small square on the guide again and fix it with the screws supplied. Align the kitchen furniture door and the appliance door by adjusting the part Hb. Do a final check to make sure that: • All screws are tightened. • The magnetic sealing strip is attached tightly to the cabinet.
electrolux
electrolux 15
www.electrolux.
